[PATCH] Kdump documentation update: ia64 portion
this patch fills in the portions for ia64 kexec.
Signed-off-by: Simon Horman <horms@verge.net.au>
Cc: "Zou, Nanhai" <nanhai.zou@intel.com>
Cc: Vivek Goyal <vgoyal@in.ibm.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/Documentation/kdump/kdump.txt b/Documentation/kdump/kdump.txt
index 2e5b317..0733068 100644
--- a/Documentation/kdump/kdump.txt
+++ b/Documentation/kdump/kdump.txt
@@ -17,7 +17,7 @@
memory image to a dump file on the local disk, or across the network to
a remote system.
-Kdump and kexec are currently supported on the x86, x86_64, ppc64 and IA64
+Kdump and kexec are currently supported on the x86, x86_64, ppc64 and ia64
architectures.
When the system kernel boots, it reserves a small section of memory for
@@ -229,7 +229,23 @@
Dump-capture kernel config options (Arch Dependent, ia64)
----------------------------------------------------------
-(To be filled)
+
+- No specific options are required to create a dump-capture kernel
+ for ia64, other than those specified in the arch idependent section
+ above. This means that it is possible to use the system kernel
+ as a dump-capture kernel if desired.
+
+ The crashkernel region can be automatically placed by the system
+ kernel at run time. This is done by specifying the base address as 0,
+ or omitting it all together.
+
+ crashkernel=256M@0
+ or
+ crashkernel=256M
+
+ If the start address is specified, note that the start address of the
+ kernel will be aligned to 64Mb, so if the start address is not then
+ any space below the alignment point will be wasted.
Boot into System Kernel
@@ -248,6 +264,10 @@
On ppc64, use "crashkernel=128M@32M".
+ On ia64, 256M@256M is a generous value that typically works.
+ The region may be automatically placed on ia64, see the
+ dump-capture kernel config option notes above.
+
Load the Dump-capture Kernel
============================
@@ -266,7 +286,8 @@
For ppc64:
- Use vmlinux
For ia64:
- (To be filled)
+ - Use vmlinux or vmlinuz.gz
+
If you are using a uncompressed vmlinux image then use following command
to load dump-capture kernel.
@@ -282,18 +303,19 @@
--initrd=<initrd-for-dump-capture-kernel> \
--append="root=<root-dev> <arch-specific-options>"
+Please note, that --args-linux does not need to be specified for ia64.
+It is planned to make this a no-op on that architecture, but for now
+it should be omitted
+
Following are the arch specific command line options to be used while
loading dump-capture kernel.
-For i386 and x86_64:
+For i386, x86_64 and ia64:
"init 1 irqpoll maxcpus=1"
For ppc64:
"init 1 maxcpus=1 noirqdistrib"
-For IA64
- (To be filled)
-
Notes on loading the dump-capture kernel: