spi/imx: select master mode for all channels
The hardware seems to have a race condition when the inactive
channels are in slave mode. We support master mode only, so
we can just switch all channels to master mode.
Signed-off-by: Sascha Hauer <s.hauer@pengutronix.de>
[ukleinek: add more verbose comment about the race]
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: Grant Likely <grant.likely@secretlab.ca>
diff --git a/drivers/spi/spi_imx.c b/drivers/spi/spi_imx.c
index 1cf9d5f..69d6dba 100644
--- a/drivers/spi/spi_imx.c
+++ b/drivers/spi/spi_imx.c
@@ -174,7 +174,7 @@
#define SPI_IMX2_3_CTRL 0x08
#define SPI_IMX2_3_CTRL_ENABLE (1 << 0)
#define SPI_IMX2_3_CTRL_XCH (1 << 2)
-#define SPI_IMX2_3_CTRL_MODE(cs) (1 << ((cs) + 4))
+#define SPI_IMX2_3_CTRL_MODE_MASK (0xf << 4)
#define SPI_IMX2_3_CTRL_POSTDIV_OFFSET 8
#define SPI_IMX2_3_CTRL_PREDIV_OFFSET 12
#define SPI_IMX2_3_CTRL_CS(cs) ((cs) << 18)
@@ -253,8 +253,14 @@
{
u32 ctrl = SPI_IMX2_3_CTRL_ENABLE, cfg = 0;
- /* set master mode */
- ctrl |= SPI_IMX2_3_CTRL_MODE(config->cs);
+ /*
+ * The hardware seems to have a race condition when changing modes. The
+ * current assumption is that the selection of the channel arrives
+ * earlier in the hardware than the mode bits when they are written at
+ * the same time.
+ * So set master mode for all channels as we do not support slave mode.
+ */
+ ctrl |= SPI_IMX2_3_CTRL_MODE_MASK;
/* set clock speed */
ctrl |= spi_imx2_3_clkdiv(spi_imx->spi_clk, config->speed_hz);