drm/i915: DP_PIPE_ENABLED must check transcoder on CPT
Display port pipe selection on CPT is not done with a bit in the
output register, rather it is controlled by a couple of bits in the
separate transcoder register which indicate which display port output
is connected to the transcoder.
This patch replaces the simplistic macro DP_PIPE_ENABLED with the
rather more complicated function dp_pipe_enabled which checks the
output register to see if that is enabled, and then goes on to either
check the output register pipe selection bit (on non-CPT) or the
transcoder DP selection bits (on CPT).
Before this patch, any time the mode of pipe A was changed, any
display port outputs on pipe B would get disabled as
intel_disable_pch_ports would ensure that the mode setting operation
could occur on pipe A without interference from other outputs
connected to that pch port
Signed-off-by: Keith Packard <keithp@keithp.com>
Reviewed-by: Jesse Barnes <jbarnes@virtuousgeek.org>
Reviewed-by: Adam Jackson <ajax@redhat.com>
diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index 5609c06..fc26cb4 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -979,11 +979,29 @@
pipe_name(pipe));
}
+static bool dp_pipe_enabled(struct drm_i915_private *dev_priv, enum pipe pipe,
+ int reg, u32 port_sel, u32 val)
+{
+ if ((val & DP_PORT_EN) == 0)
+ return false;
+
+ if (HAS_PCH_CPT(dev_priv->dev)) {
+ u32 trans_dp_ctl_reg = TRANS_DP_CTL(pipe);
+ u32 trans_dp_ctl = I915_READ(trans_dp_ctl_reg);
+ if ((trans_dp_ctl & TRANS_DP_PORT_SEL_MASK) != port_sel)
+ return false;
+ } else {
+ if ((val & DP_PIPE_MASK) != (pipe << 30))
+ return false;
+ }
+ return true;
+}
+
static void assert_pch_dp_disabled(struct drm_i915_private *dev_priv,
- enum pipe pipe, int reg)
+ enum pipe pipe, int reg, u32 port_sel)
{
u32 val = I915_READ(reg);
- WARN(DP_PIPE_ENABLED(val, pipe),
+ WARN(dp_pipe_enabled(dev_priv, pipe, reg, port_sel, val),
"PCH DP (0x%08x) enabled on transcoder %c, should be disabled\n",
reg, pipe_name(pipe));
}
@@ -1003,9 +1021,9 @@
int reg;
u32 val;
- assert_pch_dp_disabled(dev_priv, pipe, PCH_DP_B);
- assert_pch_dp_disabled(dev_priv, pipe, PCH_DP_C);
- assert_pch_dp_disabled(dev_priv, pipe, PCH_DP_D);
+ assert_pch_dp_disabled(dev_priv, pipe, PCH_DP_B, TRANS_DP_PORT_SEL_B);
+ assert_pch_dp_disabled(dev_priv, pipe, PCH_DP_C, TRANS_DP_PORT_SEL_C);
+ assert_pch_dp_disabled(dev_priv, pipe, PCH_DP_D, TRANS_DP_PORT_SEL_D);
reg = PCH_ADPA;
val = I915_READ(reg);
@@ -1334,19 +1352,24 @@
}
static void disable_pch_dp(struct drm_i915_private *dev_priv,
- enum pipe pipe, int reg)
+ enum pipe pipe, int reg, u32 port_sel)
{
u32 val = I915_READ(reg);
- if (DP_PIPE_ENABLED(val, pipe))
+ if (dp_pipe_enabled(dev_priv, pipe, reg, port_sel, val)) {
+ DRM_DEBUG_KMS("Disabling pch dp %x on pipe %d\n", reg, pipe);
I915_WRITE(reg, val & ~DP_PORT_EN);
+ }
}
static void disable_pch_hdmi(struct drm_i915_private *dev_priv,
enum pipe pipe, int reg)
{
u32 val = I915_READ(reg);
- if (HDMI_PIPE_ENABLED(val, pipe))
+ if (HDMI_PIPE_ENABLED(val, pipe)) {
+ DRM_DEBUG_KMS("Disabling pch HDMI %x on pipe %d\n",
+ reg, pipe);
I915_WRITE(reg, val & ~PORT_ENABLE);
+ }
}
/* Disable any ports connected to this transcoder */
@@ -1358,9 +1381,9 @@
val = I915_READ(PCH_PP_CONTROL);
I915_WRITE(PCH_PP_CONTROL, val | PANEL_UNLOCK_REGS);
- disable_pch_dp(dev_priv, pipe, PCH_DP_B);
- disable_pch_dp(dev_priv, pipe, PCH_DP_C);
- disable_pch_dp(dev_priv, pipe, PCH_DP_D);
+ disable_pch_dp(dev_priv, pipe, PCH_DP_B, TRANS_DP_PORT_SEL_B);
+ disable_pch_dp(dev_priv, pipe, PCH_DP_C, TRANS_DP_PORT_SEL_C);
+ disable_pch_dp(dev_priv, pipe, PCH_DP_D, TRANS_DP_PORT_SEL_D);
reg = PCH_ADPA;
val = I915_READ(reg);