[PATCH] I2O: new sysfs attributes and Adaptec specific block device access and 64-bit DMA support
Changes:
- Added Bus-OSM which could be used by user space programs to reset a
channel on the controller
- Make ioctl's in Config-OSM obsolete in prefer for sysfs attributes and
move those to its own file
- Added sysfs attribute for firmware read and write access for I2O
controllers
- Added special handling of firmware read and write access for Adaptec
controllers
- Added vendor id and product id as sysfs-attribute to Executive classes
- Added automatic notification of LCT change handling to Exec-OSM
- Added flushing function to Block-OSM for later barrier implementation
- Use PRIVATE messages for Block access on Adaptec controllers, which are
faster then BLOCK class access
- Cleaned up support for Promise controller
- New messages are now detected using the IRQ status register as
suggested by the I2O spec
- Added i2o_dma_high() and i2o_dma_low() functions
- Added facility for SG tablesize calculation when using 32-bit and
64-bit DMA addresses
- Added i2o_dma_map_single() and i2o_dma_map_sg() which could build the
SG list for 32-bit as well as 64-bit DMA addresses
Signed-off-by: Markus Lidel <Markus.Lidel@shadowconnect.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/message/i2o/i2o_proc.c b/drivers/message/i2o/i2o_proc.c
index b176d0e..e5b7445 100644
--- a/drivers/message/i2o/i2o_proc.c
+++ b/drivers/message/i2o/i2o_proc.c
@@ -228,7 +228,7 @@
case I2O_CLASS_FLOPPY_DEVICE:
idx = 12;
break;
- case I2O_CLASS_BUS_ADAPTER_PORT:
+ case I2O_CLASS_BUS_ADAPTER:
idx = 13;
break;
case I2O_CLASS_PEER_TRANSPORT_AGENT:
@@ -490,7 +490,7 @@
seq_printf(seq, ", Unknown Device Type");
break;
- case I2O_CLASS_BUS_ADAPTER_PORT:
+ case I2O_CLASS_BUS_ADAPTER:
if (lct->lct_entry[i].sub_class < BUS_TABLE_SIZE)
seq_printf(seq, ", %s",
bus_ports[lct->lct_entry[i].