consoles: polling support, kgdboc
polled console handling support, to access a console in an irq-less
way while in debug or irq context.
absolutely zero impact as long as CONFIG_CONSOLE_POLL is disabled.
(which is the default)
[ jan.kiszka@siemens.com: lots of cleanups ]
[ mingo@elte.hu: redesign, splitups, cleanups. ]
Signed-off-by: Jason Wessel <jason.wessel@windriver.com>
Signed-off-by: Ingo Molnar <mingo@elte.hu>
Signed-off-by: Jan Kiszka <jan.kiszka@web.de>
Reviewed-by: Thomas Gleixner <tglx@linutronix.de>
diff --git a/drivers/serial/8250.c b/drivers/serial/8250.c
index 77f7a7f..96a585e 100644
--- a/drivers/serial/8250.c
+++ b/drivers/serial/8250.c
@@ -1740,6 +1740,60 @@
}
}
+#ifdef CONFIG_CONSOLE_POLL
+/*
+ * Console polling routines for writing and reading from the uart while
+ * in an interrupt or debug context.
+ */
+
+static int serial8250_get_poll_char(struct uart_port *port)
+{
+ struct uart_8250_port *up = (struct uart_8250_port *)port;
+ unsigned char lsr = serial_inp(up, UART_LSR);
+
+ while (!(lsr & UART_LSR_DR))
+ lsr = serial_inp(up, UART_LSR);
+
+ return serial_inp(up, UART_RX);
+}
+
+
+static void serial8250_put_poll_char(struct uart_port *port,
+ unsigned char c)
+{
+ unsigned int ier;
+ struct uart_8250_port *up = (struct uart_8250_port *)port;
+
+ /*
+ * First save the IER then disable the interrupts
+ */
+ ier = serial_in(up, UART_IER);
+ if (up->capabilities & UART_CAP_UUE)
+ serial_out(up, UART_IER, UART_IER_UUE);
+ else
+ serial_out(up, UART_IER, 0);
+
+ wait_for_xmitr(up, BOTH_EMPTY);
+ /*
+ * Send the character out.
+ * If a LF, also do CR...
+ */
+ serial_out(up, UART_TX, c);
+ if (c == 10) {
+ wait_for_xmitr(up, BOTH_EMPTY);
+ serial_out(up, UART_TX, 13);
+ }
+
+ /*
+ * Finally, wait for transmitter to become empty
+ * and restore the IER
+ */
+ wait_for_xmitr(up, BOTH_EMPTY);
+ serial_out(up, UART_IER, ier);
+}
+
+#endif /* CONFIG_CONSOLE_POLL */
+
static int serial8250_startup(struct uart_port *port)
{
struct uart_8250_port *up = (struct uart_8250_port *)port;
@@ -2386,6 +2440,10 @@
.request_port = serial8250_request_port,
.config_port = serial8250_config_port,
.verify_port = serial8250_verify_port,
+#ifdef CONFIG_CONSOLE_POLL
+ .poll_get_char = serial8250_get_poll_char,
+ .poll_put_char = serial8250_put_poll_char,
+#endif
};
static struct uart_8250_port serial8250_ports[UART_NR];