IB/srp: Keep processing commands during host removal
Some SCSI upper layer drivers, e.g. sd, issue SCSI commands from
inside scsi_remove_host() (see the sd_shutdown() call in sd_remove()).
Make sure that these commands have a chance to reach the SCSI device.
Signed-off-by: Bart Van Assche <bvanassche@acm.org>
Acked-by: David Dillow <dillowda@ornl.gov>
Signed-off-by: Roland Dreier <roland@purestorage.com>
diff --git a/drivers/infiniband/ulp/srp/ib_srp.c b/drivers/infiniband/ulp/srp/ib_srp.c
index a226199..9371d58 100644
--- a/drivers/infiniband/ulp/srp/ib_srp.c
+++ b/drivers/infiniband/ulp/srp/ib_srp.c
@@ -1318,13 +1318,6 @@
unsigned long flags;
int len;
- if (target->state == SRP_TARGET_DEAD ||
- target->state == SRP_TARGET_REMOVED) {
- scmnd->result = DID_BAD_TARGET << 16;
- scmnd->scsi_done(scmnd);
- return 0;
- }
-
spin_lock_irqsave(&target->lock, flags);
iu = __srp_get_tx_iu(target, SRP_IU_CMD);
if (!iu)