mac80211: Fix a race on enabling power save.
There is a race on sending a data frame before the tx completion
of nullfunc frame for enabling power save. As the data quickly
follows the nullfunc frame, the AP thinks that the station is out
of power save and continues to send the frames. Whereas in the
station, the nullfunc ack will be processed after the tx completion
of data frame and mac80211 goes to powersave. Thus the power
save state mismatch between the station and the AP causes some
data loss and some applications fail because of that. This patch
fixes this issue.
Signed-off-by: Vivek Natarajan <vnatarajan@atheros.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/net/mac80211/mlme.c b/net/mac80211/mlme.c
index 7b3f9df..abb0116 100644
--- a/net/mac80211/mlme.c
+++ b/net/mac80211/mlme.c
@@ -738,9 +738,19 @@
return;
if ((local->hw.flags & IEEE80211_HW_PS_NULLFUNC_STACK) &&
- (!(ifmgd->flags & IEEE80211_STA_NULLFUNC_ACKED)))
+ (!(ifmgd->flags & IEEE80211_STA_NULLFUNC_ACKED))) {
+ netif_tx_stop_all_queues(sdata->dev);
+ /*
+ * Flush all the frames queued in the driver before
+ * going to power save
+ */
+ drv_flush(local, false);
ieee80211_send_nullfunc(local, sdata, 1);
+ /* Flush once again to get the tx status of nullfunc frame */
+ drv_flush(local, false);
+ }
+
if (!((local->hw.flags & IEEE80211_HW_REPORTS_TX_ACK_STATUS) &&
(local->hw.flags & IEEE80211_HW_PS_NULLFUNC_STACK)) ||
(ifmgd->flags & IEEE80211_STA_NULLFUNC_ACKED)) {
@@ -748,6 +758,8 @@
local->hw.conf.flags |= IEEE80211_CONF_PS;
ieee80211_hw_config(local, IEEE80211_CONF_CHANGE_PS);
}
+
+ netif_tx_start_all_queues(sdata->dev);
}
void ieee80211_dynamic_ps_timer(unsigned long data)