i2c-designware: Push all register reads/writes into the core code.
Move all register manipulation code into the core, also move register
offset definitions to i2c-designware-core.c since the bus specific
portions of the driver no longer need/use them.
Signed-off-by: Dirk Brandewie <dirk.brandewie@gmail.com>
Signed-off-by: Ben Dooks <ben-linux@fluff.org>
diff --git a/drivers/i2c/busses/i2c-designware-core.c b/drivers/i2c/busses/i2c-designware-core.c
index e8b83d90..b9f18dd 100644
--- a/drivers/i2c/busses/i2c-designware-core.c
+++ b/drivers/i2c/busses/i2c-designware-core.c
@@ -34,6 +34,108 @@
#include <linux/delay.h>
#include "i2c-designware-core.h"
+/*
+ * Registers offset
+ */
+#define DW_IC_CON 0x0
+#define DW_IC_TAR 0x4
+#define DW_IC_DATA_CMD 0x10
+#define DW_IC_SS_SCL_HCNT 0x14
+#define DW_IC_SS_SCL_LCNT 0x18
+#define DW_IC_FS_SCL_HCNT 0x1c
+#define DW_IC_FS_SCL_LCNT 0x20
+#define DW_IC_INTR_STAT 0x2c
+#define DW_IC_INTR_MASK 0x30
+#define DW_IC_RAW_INTR_STAT 0x34
+#define DW_IC_RX_TL 0x38
+#define DW_IC_TX_TL 0x3c
+#define DW_IC_CLR_INTR 0x40
+#define DW_IC_CLR_RX_UNDER 0x44
+#define DW_IC_CLR_RX_OVER 0x48
+#define DW_IC_CLR_TX_OVER 0x4c
+#define DW_IC_CLR_RD_REQ 0x50
+#define DW_IC_CLR_TX_ABRT 0x54
+#define DW_IC_CLR_RX_DONE 0x58
+#define DW_IC_CLR_ACTIVITY 0x5c
+#define DW_IC_CLR_STOP_DET 0x60
+#define DW_IC_CLR_START_DET 0x64
+#define DW_IC_CLR_GEN_CALL 0x68
+#define DW_IC_ENABLE 0x6c
+#define DW_IC_STATUS 0x70
+#define DW_IC_TXFLR 0x74
+#define DW_IC_RXFLR 0x78
+#define DW_IC_TX_ABRT_SOURCE 0x80
+#define DW_IC_COMP_PARAM_1 0xf4
+#define DW_IC_COMP_TYPE 0xfc
+#define DW_IC_COMP_TYPE_VALUE 0x44570140
+
+#define DW_IC_INTR_RX_UNDER 0x001
+#define DW_IC_INTR_RX_OVER 0x002
+#define DW_IC_INTR_RX_FULL 0x004
+#define DW_IC_INTR_TX_OVER 0x008
+#define DW_IC_INTR_TX_EMPTY 0x010
+#define DW_IC_INTR_RD_REQ 0x020
+#define DW_IC_INTR_TX_ABRT 0x040
+#define DW_IC_INTR_RX_DONE 0x080
+#define DW_IC_INTR_ACTIVITY 0x100
+#define DW_IC_INTR_STOP_DET 0x200
+#define DW_IC_INTR_START_DET 0x400
+#define DW_IC_INTR_GEN_CALL 0x800
+
+#define DW_IC_INTR_DEFAULT_MASK (DW_IC_INTR_RX_FULL | \
+ DW_IC_INTR_TX_EMPTY | \
+ DW_IC_INTR_TX_ABRT | \
+ DW_IC_INTR_STOP_DET)
+
+#define DW_IC_STATUS_ACTIVITY 0x1
+
+#define DW_IC_ERR_TX_ABRT 0x1
+
+/*
+ * status codes
+ */
+#define STATUS_IDLE 0x0
+#define STATUS_WRITE_IN_PROGRESS 0x1
+#define STATUS_READ_IN_PROGRESS 0x2
+
+#define TIMEOUT 20 /* ms */
+
+/*
+ * hardware abort codes from the DW_IC_TX_ABRT_SOURCE register
+ *
+ * only expected abort codes are listed here
+ * refer to the datasheet for the full list
+ */
+#define ABRT_7B_ADDR_NOACK 0
+#define ABRT_10ADDR1_NOACK 1
+#define ABRT_10ADDR2_NOACK 2
+#define ABRT_TXDATA_NOACK 3
+#define ABRT_GCALL_NOACK 4
+#define ABRT_GCALL_READ 5
+#define ABRT_SBYTE_ACKDET 7
+#define ABRT_SBYTE_NORSTRT 9
+#define ABRT_10B_RD_NORSTRT 10
+#define ABRT_MASTER_DIS 11
+#define ARB_LOST 12
+
+#define DW_IC_TX_ABRT_7B_ADDR_NOACK (1UL << ABRT_7B_ADDR_NOACK)
+#define DW_IC_TX_ABRT_10ADDR1_NOACK (1UL << ABRT_10ADDR1_NOACK)
+#define DW_IC_TX_ABRT_10ADDR2_NOACK (1UL << ABRT_10ADDR2_NOACK)
+#define DW_IC_TX_ABRT_TXDATA_NOACK (1UL << ABRT_TXDATA_NOACK)
+#define DW_IC_TX_ABRT_GCALL_NOACK (1UL << ABRT_GCALL_NOACK)
+#define DW_IC_TX_ABRT_GCALL_READ (1UL << ABRT_GCALL_READ)
+#define DW_IC_TX_ABRT_SBYTE_ACKDET (1UL << ABRT_SBYTE_ACKDET)
+#define DW_IC_TX_ABRT_SBYTE_NORSTRT (1UL << ABRT_SBYTE_NORSTRT)
+#define DW_IC_TX_ABRT_10B_RD_NORSTRT (1UL << ABRT_10B_RD_NORSTRT)
+#define DW_IC_TX_ABRT_MASTER_DIS (1UL << ABRT_MASTER_DIS)
+#define DW_IC_TX_ARB_LOST (1UL << ARB_LOST)
+
+#define DW_IC_TX_ABRT_NOACK (DW_IC_TX_ABRT_7B_ADDR_NOACK | \
+ DW_IC_TX_ABRT_10ADDR1_NOACK | \
+ DW_IC_TX_ABRT_10ADDR2_NOACK | \
+ DW_IC_TX_ABRT_TXDATA_NOACK | \
+ DW_IC_TX_ABRT_GCALL_NOACK)
+
static char *abort_sources[] = {
[ABRT_7B_ADDR_NOACK] =
"slave address not acknowledged (7bit mode)",
@@ -562,3 +664,36 @@
return IRQ_HANDLED;
}
+
+void i2c_dw_enable(struct dw_i2c_dev *dev)
+{
+ /* Enable the adapter */
+ dw_writel(dev, 1, DW_IC_ENABLE);
+}
+
+void i2c_dw_disable(struct dw_i2c_dev *dev)
+{
+ int ret;
+
+ /* Disable controller */
+ dw_writel(dev, 0, DW_IC_ENABLE);
+
+ /* Disable all interupts */
+ dw_writel(dev, 0, DW_IC_INTR_MASK);
+ dw_readl(dev, DW_IC_CLR_INTR);
+}
+
+void i2c_dw_clear_int(struct dw_i2c_dev *dev)
+{
+ dw_readl(dev, DW_IC_CLR_INTR);
+}
+
+void i2c_dw_disable_int(struct dw_i2c_dev *dev)
+{
+ dw_writel(dev, 0, DW_IC_INTR_MASK);
+}
+
+u32 i2c_dw_read_comp_param(struct dw_i2c_dev *dev)
+{
+ return dw_readl(dev, DW_IC_COMP_PARAM_1);
+}