regulator: core: Support bypass mode
Many regulators support a bypass mode where they simply switch their
input supply to the output. This is mainly used in low power retention
states where power consumption is extremely low so higher voltage or
less clean supplies can be used.
Support this by providing ops for the drivers and a consumer API which
allows the device to be put into bypass mode if all consumers enable it
and the machine enables permission for this.
This is not supported as a mode since the existing modes are rarely used
due to fuzzy definition and mostly redundant with modern hardware which is
able to respond promptly to load changes.
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
Reviewed-by: Graeme Gregory <gg@slimlogic.co.uk>
diff --git a/include/linux/regulator/driver.h b/include/linux/regulator/driver.h
index bac4c87..c9869cf 100644
--- a/include/linux/regulator/driver.h
+++ b/include/linux/regulator/driver.h
@@ -32,6 +32,8 @@
REGULATOR_STATUS_NORMAL,
REGULATOR_STATUS_IDLE,
REGULATOR_STATUS_STANDBY,
+ /* The regulator is enabled but not regulating */
+ REGULATOR_STATUS_BYPASS,
/* in case that any other status doesn't apply */
REGULATOR_STATUS_UNDEFINED,
};
@@ -67,6 +69,9 @@
* @get_optimum_mode: Get the most efficient operating mode for the regulator
* when running with the specified parameters.
*
+ * @set_bypass: Set the regulator in bypass mode.
+ * @get_bypass: Get the regulator bypass mode state.
+ *
* @enable_time: Time taken for the regulator voltage output voltage to
* stabilise after being enabled, in microseconds.
* @set_ramp_delay: Set the ramp delay for the regulator. The driver should
@@ -133,6 +138,10 @@
unsigned int (*get_optimum_mode) (struct regulator_dev *, int input_uV,
int output_uV, int load_uA);
+ /* control and report on bypass mode */
+ int (*set_bypass)(struct regulator_dev *dev, bool enable);
+ int (*get_bypass)(struct regulator_dev *dev, bool *enable);
+
/* the operations below are for configuration of regulator state when
* its parent PMIC enters a global STANDBY/HIBERNATE state */
@@ -253,6 +262,7 @@
int exclusive;
u32 use_count;
u32 open_count;
+ u32 bypass_count;
/* lists we belong to */
struct list_head list; /* list of all regulators */