diff --git a/Documentation/braille-console.txt b/Documentation/braille-console.txt
new file mode 100644
index 0000000..000b0fb
--- /dev/null
+++ b/Documentation/braille-console.txt
@@ -0,0 +1,34 @@
+                       Linux Braille Console
+
+To get early boot messages on a braille device (before userspace screen
+readers can start), you first need to compile the support for the usual serial
+console (see serial-console.txt), and for braille device (in Device Drivers -
+Accessibility).
+
+Then you need to specify a console=brl, option on the kernel command line, the
+format is:
+
+	console=brl,serial_options...
+
+where serial_options... are the same as described in serial-console.txt
+
+So for instance you can use console=brl,ttyS0 if the braille device is connected
+to the first serial port, and console=brl,ttyS0,115200 to override the baud rate
+to 115200, etc.
+
+By default, the braille device will just show the last kernel message (console
+mode).  To review previous messages, press the Insert key to switch to the VT
+review mode.  In review mode, the arrow keys permit to browse in the VT content,
+page up/down keys go at the top/bottom of the screen, and the home key goes back
+to the cursor, hence providing very basic screen reviewing facility.
+
+Sound feedback can be obtained by adding the braille_console.sound=1 kernel
+parameter.
+
+For simplicity, only one braille console can be enabled, other uses of
+console=brl,... will be discarded.  Also note that it does not interfere with
+the console selection mecanism described in serial-console.txt
+
+For now, only the VisioBraille device is supported.
+
+Samuel Thibault <samuel.thibault@ens-lyon.org>