diff --git a/drivers/usb/gadget/s3c-hsotg.c b/drivers/usb/gadget/s3c-hsotg.c
index f39daf7..c0ff1cb 100644
--- a/drivers/usb/gadget/s3c-hsotg.c
+++ b/drivers/usb/gadget/s3c-hsotg.c
@@ -146,6 +146,7 @@
  * @regs: The memory area mapped for accessing registers.
  * @irq: The IRQ number we are using
  * @supplies: Definition of USB power supplies
+ * @phyif: PHY interface width
  * @dedicated_fifos: Set if the hardware has dedicated IN-EP fifos.
  * @num_of_eps: Number of available EPs (excluding EP0)
  * @debug_root: root directrory for debugfs.
@@ -174,6 +175,7 @@
 
 	struct regulator_bulk_data supplies[ARRAY_SIZE(s3c_hsotg_supply_names)];
 
+	u32			phyif;
 	unsigned int		dedicated_fifos:1;
 	unsigned char           num_of_eps;
 
@@ -2288,7 +2290,7 @@
 	 */
 
 	/* set the PLL on, remove the HNP/SRP and set the PHY */
-	writel(GUSBCFG_PHYIf16 | GUSBCFG_TOutCal(7) |
+	writel(hsotg->phyif | GUSBCFG_TOutCal(7) |
 	       (0x5 << 10), hsotg->regs + GUSBCFG);
 
 	s3c_hsotg_init_fifo(hsotg);
@@ -3646,6 +3648,16 @@
 		goto err_supplies;
 	}
 
+	/* Set default UTMI width */
+	hsotg->phyif = GUSBCFG_PHYIf16;
+
+	/*
+	 * If using the generic PHY framework, check if the PHY bus
+	 * width is 8-bit and set the phyif appropriately.
+	 */
+	if (hsotg->phy && (phy_get_bus_width(phy) == 8))
+		hsotg->phyif = GUSBCFG_PHYIf8;
+
 	if (hsotg->phy)
 		phy_init(hsotg->phy);