arm64: add support for kernel ASLR
This adds support for KASLR is implemented, based on entropy provided by
the bootloader in the /chosen/kaslr-seed DT property. Depending on the size
of the address space (VA_BITS) and the page size, the entropy in the
virtual displacement is up to 13 bits (16k/2 levels) and up to 25 bits (all
4 levels), with the sidenote that displacements that result in the kernel
image straddling a 1GB/32MB/512MB alignment boundary (for 4KB/16KB/64KB
granule kernels, respectively) are not allowed, and will be rounded up to
an acceptable value.
If CONFIG_RANDOMIZE_MODULE_REGION_FULL is enabled, the module region is
randomized independently from the core kernel. This makes it less likely
that the location of core kernel data structures can be determined by an
adversary, but causes all function calls from modules into the core kernel
to be resolved via entries in the module PLTs.
If CONFIG_RANDOMIZE_MODULE_REGION_FULL is not enabled, the module region is
randomized by choosing a page aligned 128 MB region inside the interval
[_etext - 128 MB, _stext + 128 MB). This gives between 10 and 14 bits of
entropy (depending on page size), independently of the kernel randomization,
but still guarantees that modules are within the range of relative branch
and jump instructions (with the caveat that, since the module region is
shared with other uses of the vmalloc area, modules may need to be loaded
further away if the module region is exhausted)
Signed-off-by: Ard Biesheuvel <ard.biesheuvel@linaro.org>
Signed-off-by: Catalin Marinas <catalin.marinas@arm.com>
diff --git a/arch/arm64/mm/kasan_init.c b/arch/arm64/mm/kasan_init.c
index 7f10cc9..56e19d1 100644
--- a/arch/arm64/mm/kasan_init.c
+++ b/arch/arm64/mm/kasan_init.c
@@ -129,12 +129,16 @@
void __init kasan_init(void)
{
u64 kimg_shadow_start, kimg_shadow_end;
+ u64 mod_shadow_start, mod_shadow_end;
struct memblock_region *reg;
int i;
kimg_shadow_start = (u64)kasan_mem_to_shadow(_text);
kimg_shadow_end = (u64)kasan_mem_to_shadow(_end);
+ mod_shadow_start = (u64)kasan_mem_to_shadow((void *)MODULES_VADDR);
+ mod_shadow_end = (u64)kasan_mem_to_shadow((void *)MODULES_END);
+
/*
* We are going to perform proper setup of shadow memory.
* At first we should unmap early shadow (clear_pgds() call bellow).
@@ -158,13 +162,20 @@
* with PMD table mappings at the edges of the shadow region for the
* kernel image.
*/
- if (ARM64_SWAPPER_USES_SECTION_MAPS)
+ if (ARM64_SWAPPER_USES_SECTION_MAPS) {
+ kimg_shadow_start = round_down(kimg_shadow_start,
+ SWAPPER_BLOCK_SIZE);
kimg_shadow_end = round_up(kimg_shadow_end, SWAPPER_BLOCK_SIZE);
+ }
kasan_populate_zero_shadow((void *)KASAN_SHADOW_START,
- kasan_mem_to_shadow((void *)MODULES_VADDR));
+ (void *)mod_shadow_start);
kasan_populate_zero_shadow((void *)kimg_shadow_end,
- kasan_mem_to_shadow((void *)PAGE_OFFSET));
+ kasan_mem_to_shadow((void *)PAGE_OFFSET));
+
+ if (kimg_shadow_start > mod_shadow_end)
+ kasan_populate_zero_shadow((void *)mod_shadow_end,
+ (void *)kimg_shadow_start);
for_each_memblock(memory, reg) {
void *start = (void *)__phys_to_virt(reg->base);