cfg80211: clean up mesh plink station change API
Make the ability to leave the plink_state unchanged not use a
magic -1 variable that isn't in the enum, but an explicit change
flag; reject invalid plink states or actions and move the needed
constants for plink actions to the right header file. Also
reject plink_state changes for non-mesh interfaces.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
diff --git a/include/net/cfg80211.h b/include/net/cfg80211.h
index d581c6d..9b54574 100644
--- a/include/net/cfg80211.h
+++ b/include/net/cfg80211.h
@@ -611,22 +611,10 @@
};
/**
- * enum plink_action - actions to perform in mesh peers
- *
- * @PLINK_ACTION_INVALID: action 0 is reserved
- * @PLINK_ACTION_OPEN: start mesh peer link establishment
- * @PLINK_ACTION_BLOCK: block traffic from this mesh peer
- */
-enum plink_actions {
- PLINK_ACTION_INVALID,
- PLINK_ACTION_OPEN,
- PLINK_ACTION_BLOCK,
-};
-
-/**
* enum station_parameters_apply_mask - station parameter values to apply
* @STATION_PARAM_APPLY_UAPSD: apply new uAPSD parameters (uapsd_queues, max_sp)
* @STATION_PARAM_APPLY_CAPABILITY: apply new capability
+ * @STATION_PARAM_APPLY_PLINK_STATE: apply new plink state
*
* Not all station parameters have in-band "no change" signalling,
* for those that don't these flags will are used.
@@ -634,6 +622,7 @@
enum station_parameters_apply_mask {
STATION_PARAM_APPLY_UAPSD = BIT(0),
STATION_PARAM_APPLY_CAPABILITY = BIT(1),
+ STATION_PARAM_APPLY_PLINK_STATE = BIT(2),
};
/**