MIPS: KVM: Add CP0_Count/Compare KVM register access
Implement KVM_{GET,SET}_ONE_REG ioctl based access to the guest CP0
Count and Compare registers. These registers are special in that writing
to them has side effects (adjusting the time until the next timer
interrupt) and reading of Count depends on the time. Therefore add a
couple of callbacks so that different implementations (trap & emulate or
VZ) can implement them differently depending on what the hardware
provides.
The trap & emulate versions mostly duplicate what happens when a T&E
guest reads or writes these registers, so it inherits the same
limitations which can be fixed in later patches.
Signed-off-by: James Hogan <james.hogan@imgtec.com>
Cc: Paolo Bonzini <pbonzini@redhat.com>
Cc: Gleb Natapov <gleb@kernel.org>
Cc: kvm@vger.kernel.org
Cc: Ralf Baechle <ralf@linux-mips.org>
Cc: linux-mips@linux-mips.org
Cc: David Daney <david.daney@cavium.com>
Cc: Sanjay Lal <sanjayl@kymasys.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>
diff --git a/arch/mips/kvm/kvm_mips.c b/arch/mips/kvm/kvm_mips.c
index 3f52d72..61d834c 100644
--- a/arch/mips/kvm/kvm_mips.c
+++ b/arch/mips/kvm/kvm_mips.c
@@ -529,7 +529,9 @@
KVM_REG_MIPS_CP0_PAGEMASK,
KVM_REG_MIPS_CP0_WIRED,
KVM_REG_MIPS_CP0_BADVADDR,
+ KVM_REG_MIPS_CP0_COUNT,
KVM_REG_MIPS_CP0_ENTRYHI,
+ KVM_REG_MIPS_CP0_COMPARE,
KVM_REG_MIPS_CP0_STATUS,
KVM_REG_MIPS_CP0_CAUSE,
KVM_REG_MIPS_CP0_EPC,
@@ -545,6 +547,7 @@
const struct kvm_one_reg *reg)
{
struct mips_coproc *cop0 = vcpu->arch.cop0;
+ int ret;
s64 v;
switch (reg->id) {
@@ -579,6 +582,9 @@
case KVM_REG_MIPS_CP0_ENTRYHI:
v = (long)kvm_read_c0_guest_entryhi(cop0);
break;
+ case KVM_REG_MIPS_CP0_COMPARE:
+ v = (long)kvm_read_c0_guest_compare(cop0);
+ break;
case KVM_REG_MIPS_CP0_STATUS:
v = (long)kvm_read_c0_guest_status(cop0);
break;
@@ -606,6 +612,12 @@
case KVM_REG_MIPS_CP0_CONFIG7:
v = (long)kvm_read_c0_guest_config7(cop0);
break;
+ /* registers to be handled specially */
+ case KVM_REG_MIPS_CP0_COUNT:
+ ret = kvm_mips_callbacks->get_one_reg(vcpu, reg, &v);
+ if (ret)
+ return ret;
+ break;
default:
return -EINVAL;
}
@@ -690,6 +702,10 @@
case KVM_REG_MIPS_CP0_ERROREPC:
kvm_write_c0_guest_errorepc(cop0, v);
break;
+ /* registers to be handled specially */
+ case KVM_REG_MIPS_CP0_COUNT:
+ case KVM_REG_MIPS_CP0_COMPARE:
+ return kvm_mips_callbacks->set_one_reg(vcpu, reg, v);
default:
return -EINVAL;
}