ASoC: 88pm60x: Don't use control data for i2c
In preparation for using the regmap directly in the CODEC driver replace
references to the I2C client using control_data with references to the
driver private data.
Signed-off-by: Mark Brown <broonie@linaro.org>
diff --git a/sound/soc/codecs/88pm860x-codec.c b/sound/soc/codecs/88pm860x-codec.c
index 8af0434..3925cf3 100644
--- a/sound/soc/codecs/88pm860x-codec.c
+++ b/sound/soc/codecs/88pm860x-codec.c
@@ -1166,6 +1166,7 @@
static int pm860x_set_bias_level(struct snd_soc_codec *codec,
enum snd_soc_bias_level level)
{
+ struct pm860x_priv *pm860x = snd_soc_codec_get_drvdata(codec);
int data;
switch (level) {
@@ -1179,17 +1180,17 @@
if (codec->dapm.bias_level == SND_SOC_BIAS_OFF) {
/* Enable Audio PLL & Audio section */
data = AUDIO_PLL | AUDIO_SECTION_ON;
- pm860x_reg_write(codec->control_data, REG_MISC2, data);
+ pm860x_reg_write(pm860x->i2c, REG_MISC2, data);
udelay(300);
data = AUDIO_PLL | AUDIO_SECTION_RESET
| AUDIO_SECTION_ON;
- pm860x_reg_write(codec->control_data, REG_MISC2, data);
+ pm860x_reg_write(pm860x->i2c, REG_MISC2, data);
}
break;
case SND_SOC_BIAS_OFF:
data = AUDIO_PLL | AUDIO_SECTION_RESET | AUDIO_SECTION_ON;
- pm860x_set_bits(codec->control_data, REG_MISC2, data, 0);
+ pm860x_set_bits(pm860x->i2c, REG_MISC2, data, 0);
break;
}
codec->dapm.bias_level = level;
@@ -1319,17 +1320,17 @@
pm860x->det.lo_shrt = lo_shrt;
if (det & SND_JACK_HEADPHONE)
- pm860x_set_bits(codec->control_data, REG_HS_DET,
+ pm860x_set_bits(pm860x->i2c, REG_HS_DET,
EN_HS_DET, EN_HS_DET);
/* headset short detect */
if (hs_shrt) {
data = CLR_SHORT_HS2 | CLR_SHORT_HS1;
- pm860x_set_bits(codec->control_data, REG_SHORTS, data, data);
+ pm860x_set_bits(pm860x->i2c, REG_SHORTS, data, data);
}
/* Lineout short detect */
if (lo_shrt) {
data = CLR_SHORT_LO2 | CLR_SHORT_LO1;
- pm860x_set_bits(codec->control_data, REG_SHORTS, data, data);
+ pm860x_set_bits(pm860x->i2c, REG_SHORTS, data, data);
}
/* sync status */
@@ -1347,7 +1348,7 @@
pm860x->det.mic_det = det;
if (det & SND_JACK_MICROPHONE)
- pm860x_set_bits(codec->control_data, REG_MIC_DET,
+ pm860x_set_bits(pm860x->i2c, REG_MIC_DET,
MICDET_MASK, MICDET_MASK);
/* sync status */
@@ -1377,7 +1378,7 @@
pm860x_set_bias_level(codec, SND_SOC_BIAS_STANDBY);
- ret = pm860x_bulk_read(codec->control_data, REG_CACHE_BASE,
+ ret = pm860x_bulk_read(pm860x->i2c, REG_CACHE_BASE,
REG_CACHE_SIZE, codec->reg_cache);
if (ret < 0) {
dev_err(codec->dev, "Failed to fill register cache: %d\n",