net/mlx4_core: Add basic support for QP max-rate limiting
Add the low-level device commands and definitions used for QP max-rate limiting.
This is done through the following elements:
- read rate-limit device caps in QUERY_DEV_CAP: number of different
rates and the min/max rates in Kbs/Mbs/Gbs units
- enhance the QP context struct to contain rate limit units and value
- allow to do run time rate-limit setting to QPs through the
update-qp firmware command
- QP rate-limiting is disallowed for VFs
Signed-off-by: Or Gerlitz <ogerlitz@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/include/linux/mlx4/qp.h b/include/linux/mlx4/qp.h
index 551f854..1023ebe 100644
--- a/include/linux/mlx4/qp.h
+++ b/include/linux/mlx4/qp.h
@@ -207,14 +207,16 @@
__be32 msn;
__be16 rq_wqe_counter;
__be16 sq_wqe_counter;
- u32 reserved3[2];
+ u32 reserved3;
+ __be16 rate_limit_params;
+ __be16 reserved4;
__be32 param3;
__be32 nummmcpeers_basemkey;
u8 log_page_size;
- u8 reserved4[2];
+ u8 reserved5[2];
u8 mtt_base_addr_h;
__be32 mtt_base_addr_l;
- u32 reserved5[10];
+ u32 reserved6[10];
};
struct mlx4_update_qp_context {
@@ -229,6 +231,7 @@
enum {
MLX4_UPD_QP_MASK_PM_STATE = 32,
MLX4_UPD_QP_MASK_VSD = 33,
+ MLX4_UPD_QP_MASK_RATE_LIMIT = 35,
};
enum {
@@ -428,7 +431,8 @@
enum mlx4_update_qp_attr {
MLX4_UPDATE_QP_SMAC = 1 << 0,
MLX4_UPDATE_QP_VSD = 1 << 1,
- MLX4_UPDATE_QP_SUPPORTED_ATTRS = (1 << 2) - 1
+ MLX4_UPDATE_QP_RATE_LIMIT = 1 << 2,
+ MLX4_UPDATE_QP_SUPPORTED_ATTRS = (1 << 3) - 1
};
enum mlx4_update_qp_params_flags {
@@ -438,6 +442,8 @@
struct mlx4_update_qp_params {
u8 smac_index;
u32 flags;
+ u16 rate_unit;
+ u16 rate_val;
};
int mlx4_update_qp(struct mlx4_dev *dev, u32 qpn,