regulator: wm8350: Convert LDOs to set_voltage_sel()
Since there are two linear ranges for the LDO voltages provide a voltage
mapping function and then use regulator_set_voltage_sel_regmap().
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
diff --git a/drivers/regulator/wm8350-regulator.c b/drivers/regulator/wm8350-regulator.c
index 33c37f9..ca678ee 100644
--- a/drivers/regulator/wm8350-regulator.c
+++ b/drivers/regulator/wm8350-regulator.c
@@ -671,13 +671,12 @@
return 0;
}
-static int wm8350_ldo_set_voltage(struct regulator_dev *rdev, int min_uV,
- int max_uV, unsigned *selector)
+static int wm8350_ldo_map_voltage(struct regulator_dev *rdev, int min_uV,
+ int max_uV)
{
- struct wm8350 *wm8350 = rdev_get_drvdata(rdev);
- int volt_reg, ldo = rdev_get_id(rdev), mV, min_mV = min_uV / 1000,
- max_mV = max_uV / 1000;
- u16 val;
+ int mV;
+ int min_mV = min_uV / 1000;
+ int max_mV = max_uV / 1000;
if (min_mV < 900 || min_mV > 3300)
return -EINVAL;
@@ -698,29 +697,7 @@
BUG_ON(wm8350_ldo_val_to_mvolts(mV) < min_mV);
}
- switch (ldo) {
- case WM8350_LDO_1:
- volt_reg = WM8350_LDO1_CONTROL;
- break;
- case WM8350_LDO_2:
- volt_reg = WM8350_LDO2_CONTROL;
- break;
- case WM8350_LDO_3:
- volt_reg = WM8350_LDO3_CONTROL;
- break;
- case WM8350_LDO_4:
- volt_reg = WM8350_LDO4_CONTROL;
- break;
- default:
- return -EINVAL;
- }
-
- *selector = mV;
-
- /* all LDOs have same mV bits */
- val = wm8350_reg_read(wm8350, volt_reg) & ~WM8350_LDO1_VSEL_MASK;
- wm8350_reg_write(wm8350, volt_reg, val | mV);
- return 0;
+ return mV;
}
static int wm8350_ldo_list_voltage(struct regulator_dev *rdev,
@@ -1058,7 +1035,8 @@
};
static struct regulator_ops wm8350_ldo_ops = {
- .set_voltage = wm8350_ldo_set_voltage,
+ .map_voltage = wm8350_ldo_map_voltage,
+ .set_voltage_sel = regulator_set_voltage_sel_regmap,
.get_voltage_sel = regulator_get_voltage_sel_regmap,
.list_voltage = wm8350_ldo_list_voltage,
.enable = regulator_enable_regmap,