regulator: wm8350: Convert LDOs to set_voltage_sel()

Since there are two linear ranges for the LDO voltages provide a voltage
mapping function and then use regulator_set_voltage_sel_regmap().

Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
diff --git a/drivers/regulator/wm8350-regulator.c b/drivers/regulator/wm8350-regulator.c
index 33c37f9..ca678ee 100644
--- a/drivers/regulator/wm8350-regulator.c
+++ b/drivers/regulator/wm8350-regulator.c
@@ -671,13 +671,12 @@
 	return 0;
 }
 
-static int wm8350_ldo_set_voltage(struct regulator_dev *rdev, int min_uV,
-				  int max_uV, unsigned *selector)
+static int wm8350_ldo_map_voltage(struct regulator_dev *rdev, int min_uV,
+				  int max_uV)
 {
-	struct wm8350 *wm8350 = rdev_get_drvdata(rdev);
-	int volt_reg, ldo = rdev_get_id(rdev), mV, min_mV = min_uV / 1000,
-		max_mV = max_uV / 1000;
-	u16 val;
+	int mV;
+	int min_mV = min_uV / 1000;
+	int max_mV = max_uV / 1000;
 
 	if (min_mV < 900 || min_mV > 3300)
 		return -EINVAL;
@@ -698,29 +697,7 @@
 		BUG_ON(wm8350_ldo_val_to_mvolts(mV) < min_mV);
 	}
 
-	switch (ldo) {
-	case WM8350_LDO_1:
-		volt_reg = WM8350_LDO1_CONTROL;
-		break;
-	case WM8350_LDO_2:
-		volt_reg = WM8350_LDO2_CONTROL;
-		break;
-	case WM8350_LDO_3:
-		volt_reg = WM8350_LDO3_CONTROL;
-		break;
-	case WM8350_LDO_4:
-		volt_reg = WM8350_LDO4_CONTROL;
-		break;
-	default:
-		return -EINVAL;
-	}
-
-	*selector = mV;
-
-	/* all LDOs have same mV bits */
-	val = wm8350_reg_read(wm8350, volt_reg) & ~WM8350_LDO1_VSEL_MASK;
-	wm8350_reg_write(wm8350, volt_reg, val | mV);
-	return 0;
+	return mV;
 }
 
 static int wm8350_ldo_list_voltage(struct regulator_dev *rdev,
@@ -1058,7 +1035,8 @@
 };
 
 static struct regulator_ops wm8350_ldo_ops = {
-	.set_voltage = wm8350_ldo_set_voltage,
+	.map_voltage = wm8350_ldo_map_voltage,
+	.set_voltage_sel = regulator_set_voltage_sel_regmap,
 	.get_voltage_sel = regulator_get_voltage_sel_regmap,
 	.list_voltage = wm8350_ldo_list_voltage,
 	.enable = regulator_enable_regmap,