bnx2x: Change duplex setting in EEE function
This is not a real problem, since the EEE is supported for devices where the
actual_phy_selection is zero, such that the req_duplex of params will match
the one of the phy struct.
Signed-off-by: Yaniv Rosner <yanivr@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
index ebab35d..3e7d824 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_link.c
@@ -10119,7 +10119,7 @@
return rc;
}
- if ((params->req_duplex[actual_phy_selection] == DUPLEX_FULL) &&
+ if ((phy->req_duplex == DUPLEX_FULL) &&
(params->eee_mode & EEE_MODE_ADV_LPI) &&
(bnx2x_eee_calc_timer(params) ||
!(params->eee_mode & EEE_MODE_ENABLE_LPI)))
@@ -13451,7 +13451,7 @@
if (!(vars->link_attr_sync & LINK_ATTR_SYNC_KR2_ENABLE)) {
if (!not_kr2_device) {
DP(NETIF_MSG_LINK, "BP=0x%x, NP=0x%x\n", base_page,
- next_page);
+ next_page);
bnx2x_kr2_recovery(params, vars, phy);
}
return;