net/mlx4_core: Respond to operation request by firmware
This commit adds new firmware command and new firmware event. The firmware
raises the MLX4_EVENT_TYPE_OP_REQUIRED event in order to signal the driver it
needs to perform an administrative operation throughout the MLX4_CMD_GET_OP_REQ
command. At the moment the supported operation is adding/removing multicast
entries which are used by the firmware for handling NCSI traffic in B0
steering mode.
Also, had to swap the order of mlx4_init_mcg_table() and
mlx4_init_eq_table() to make sure that driver will get events only after
resources are initialized to handle it.
Signed-off-by: Yevgeny Petrilin <yevgenyp@mellanox.com>
Signed-off-by: Jack Morgenstein <jackm@dev.mellanox.com>
Signed-off-by: Eugenia Emantayev <eugenia@mellanox.com>
Signed-off-by: Amir Vadai <amirv@mellanox.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/mellanox/mlx4/cmd.c b/drivers/net/ethernet/mellanox/mlx4/cmd.c
index 299d018..141322c 100644
--- a/drivers/net/ethernet/mellanox/mlx4/cmd.c
+++ b/drivers/net/ethernet/mellanox/mlx4/cmd.c
@@ -809,6 +809,15 @@
return -EPERM;
}
+int MLX4_CMD_GET_OP_REQ_wrapper(struct mlx4_dev *dev, int slave,
+ struct mlx4_vhcr *vhcr,
+ struct mlx4_cmd_mailbox *inbox,
+ struct mlx4_cmd_mailbox *outbox,
+ struct mlx4_cmd_info *cmd)
+{
+ return -EPERM;
+}
+
int mlx4_DMA_wrapper(struct mlx4_dev *dev, int slave,
struct mlx4_vhcr *vhcr,
struct mlx4_cmd_mailbox *inbox,
@@ -1252,6 +1261,15 @@
.wrapper = MLX4_CMD_UPDATE_QP_wrapper
},
{
+ .opcode = MLX4_CMD_GET_OP_REQ,
+ .has_inbox = false,
+ .has_outbox = false,
+ .out_is_imm = false,
+ .encode_slave_id = false,
+ .verify = NULL,
+ .wrapper = MLX4_CMD_GET_OP_REQ_wrapper,
+ },
+ {
.opcode = MLX4_CMD_CONF_SPECIAL_QP,
.has_inbox = false,
.has_outbox = false,