Input: add driver for Sharp gp2ap002a00f proximity sensor
This driver adds support for Sharp's GP2AP002A00F proximity sensor. The
proximity is measured as a binary switch, i.e. an object is either
detected or not detected. Hence, this driver is implemented as a switch
that reports SW_FRONT_PROXIMITY.
Reviewed-by: Datta Shubhrajyoti <shubhrajyoti@ti.com>
Signed-off-by: Courtney Cavin <courtney.cavin@sonyericsson.com>
Signed-off-by: Oskar Andero <oskar.andero@sonyericsson.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
diff --git a/drivers/input/misc/Kconfig b/drivers/input/misc/Kconfig
index e53b443..7b46781 100644
--- a/drivers/input/misc/Kconfig
+++ b/drivers/input/misc/Kconfig
@@ -179,6 +179,17 @@
To compile this driver as a module, choose M here: the module will
be called apanel.
+config INPUT_GP2A
+ tristate "Sharp GP2AP002A00F I2C Proximity/Opto sensor driver"
+ depends on I2C
+ depends on GENERIC_GPIO
+ help
+ Say Y here if you have a Sharp GP2AP002A00F proximity/als combo-chip
+ hooked to an I2C bus.
+
+ To compile this driver as a module, choose M here: the
+ module will be called gp2ap002a00f.
+
config INPUT_GPIO_TILT_POLLED
tristate "Polled GPIO tilt switch"
depends on GENERIC_GPIO