ucc_geth: use correct thread number for 10/100Mbps link
Use thread number of 1 for 10/100Mbps link instead of 4.
Signed-off-by: Joakim Tjernlund <Joakim.Tjernlund@transmode.se>
Signed-off-by: Li Yang <leoli@freescale.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/ucc_geth.c b/drivers/net/ucc_geth.c
index fba0811..8cc3166 100644
--- a/drivers/net/ucc_geth.c
+++ b/drivers/net/ucc_geth.c
@@ -154,8 +154,8 @@
.rxQoSMode = UCC_GETH_QOS_MODE_DEFAULT,
.aufc = UPSMR_AUTOMATIC_FLOW_CONTROL_MODE_NONE,
.padAndCrc = MACCFG2_PAD_AND_CRC_MODE_PAD_AND_CRC,
- .numThreadsTx = UCC_GETH_NUM_OF_THREADS_4,
- .numThreadsRx = UCC_GETH_NUM_OF_THREADS_4,
+ .numThreadsTx = UCC_GETH_NUM_OF_THREADS_1,
+ .numThreadsRx = UCC_GETH_NUM_OF_THREADS_1,
.riscTx = QE_RISC_ALLOCATION_RISC1_AND_RISC2,
.riscRx = QE_RISC_ALLOCATION_RISC1_AND_RISC2,
};
@@ -3975,6 +3975,8 @@
ug_info->uf_info.utfs = UCC_GETH_UTFS_GIGA_INIT;
ug_info->uf_info.utfet = UCC_GETH_UTFET_GIGA_INIT;
ug_info->uf_info.utftt = UCC_GETH_UTFTT_GIGA_INIT;
+ ug_info->numThreadsTx = UCC_GETH_NUM_OF_THREADS_4;
+ ug_info->numThreadsRx = UCC_GETH_NUM_OF_THREADS_4;
}
/* Set the bus id */