drm/i915: clarify why we need to enable fdi plls so early
For reference, see "Graphics BSpec: vol4g North Display Engine
Registers [IVB], Display Mode Set Sequence", step 4 of the enabling
sequence:
a. "Enable PCH FDI Receiver PLL, wait for warmup plus DMI latency
b. "Switch from Rawclk to PCDclk in FDI Receiver
c. "Enable CPU FDI Transmitter PLL, wait for warmup"
Cc: Paulo Zanoni <przanoni@gmail.com>
Reviewed-by: Paulo Zanoni <paulo.r.zanoni@intel.com>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index 54b1794..612b410 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -3227,6 +3227,9 @@
is_pch_port = ironlake_crtc_driving_pch(crtc);
if (is_pch_port) {
+ /* Note: FDI PLL enabling _must_ be done before we enable the
+ * cpu pipes, hence this is separate from all the other fdi/pch
+ * enabling. */
ironlake_fdi_pll_enable(intel_crtc);
} else {
assert_fdi_tx_disabled(dev_priv, pipe);