| Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame] | 1 | To configure the Crystal CS423x sound chip and activate its DSP functions, |
| 2 | modules may be loaded in this order: |
| 3 | |
| 4 | modprobe sound |
| 5 | insmod ad1848 |
| 6 | insmod uart401 |
| 7 | insmod cs4232 io=* irq=* dma=* dma2=* |
| 8 | |
| 9 | This is the meaning of the parameters: |
| 10 | |
| 11 | io--I/O address of the Windows Sound System (normally 0x534) |
| 12 | irq--IRQ of this device |
| 13 | dma and dma2--DMA channels (DMA2 may be 0) |
| 14 | |
| 15 | On some cards, the board attempts to do non-PnP setup, and fails. If you |
| 16 | have problems, use Linux' PnP facilities. |
| 17 | |
| 18 | To get MIDI facilities add |
| 19 | |
| 20 | insmod opl3 io=* |
| 21 | |
| 22 | where "io" is the I/O address of the OPL3 synthesizer. This will be shown |
| 23 | in /proc/sys/pnp and is normally 0x388. |