blob: 6888ae0d0ce0ae2eb06ccfa29b61c808a721595c [file] [log] [blame]
Linus Torvalds1da177e2005-04-16 15:20:36 -07001/*
2 * PLX 9060 PCI Interface chip
3 */
4
5/*
6 * PCI configuration registers, same offset on local and PCI sides,
7 * but on PCI side, must use PCI BIOS calls to read/write.
8 */
9#define PCI_PLXREGS_BASE_ADDR 0x10
10
11#define PCI_PLXREGS_IO_ADDR 0x14
12
13#define PCI_SPACE0_BASE_ADDR 0x18
14
15#define PCI_ROM_BASE_ADDR 0x30
16# define PCI_ROM_ENABLED 0x00000001
17
18#define PCI_INT_LINE 0x3C
19
20/*
21 * Registers accessible directly from PCI and local side.
22 * Offset is from PCI side. Add PLX_LCL_OFFSET for local address.
23 */
24#define PLX_LCL_OFFSET 0x80 /* Offset of regs from local side */
25
26/*
27 * Local Configuration Registers
28 */
29#define PLX_SPACE0_RANGE 0x00 /* Range for PCI to Lcl Addr Space 0 */
30#define PLX_SPACE0_BASE_ADDR 0x04 /* Lcl Base address remap */
31
32#define PLX_ROM_RANGE 0x10 /* Range for expansion ROM (DMA) */
33#define PLX_ROM_BASE_ADDR 0x14 /* Lcl base address remap for ROM */
34
35#define PLX_BUS_REGION 0x18 /* Bus Region Descriptors */
36
37/*
38 * Shared Run Time Registers
39 */
40#define PLX_MBOX0 0x40
41#define PLX_MBOX1 0x44
42#define PLX_MBOX2 0x48
43#define PLX_MBOX3 0x4C
44#define PLX_MBOX4 0x50
45#define PLX_MBOX5 0x54
46#define PLX_MBOX6 0x58
47#define PLX_MBOX7 0x5C
48
49#define PLX_PCI2LCL_DOORBELL 0x60
50
51#define PLX_LCL2PCI_DOORBELL 0x64
52
53#define PLX_INT_CSR 0x68 /* Interrupt Control/Status */
54# define PLX_LSERR_ENABLE 0x00000001
55# define PLX_LSERR_PE 0x00000002
56# define PLX_SERR 0x00000004
57# undef PLX_UNUSED /* 0x00000008 */
58# undef PLX_UNUSED /* 0x00000010 */
59# undef PLX_UNUSED /* 0x00000020 */
60# undef PLX_UNUSED /* 0x00000040 */
61# undef PLX_UNUSED /* 0x00000080 */
62# define PLX_PCI_IE 0x00000100
63# define PLX_PCI_DOORBELL_IE 0x00000200
64# define PLX_PCI_ABORT_IE 0x00000400
65# define PLX_PCI_LOCAL_IE 0x00000800
66# define PLX_RETRY_ABORT_ENABLE 0x00001000
67# define PLX_PCI_DOORBELL_INT 0x00002000
68# define PLX_PCI_ABORT_INT 0x00004000
69# define PLX_PCI_LOCAL_INT 0x00008000
70# define PLX_LCL_IE 0x00010000
71# define PLX_LCL_DOORBELL_IE 0x00020000
72# define PLX_LCL_DMA0_IE 0x00040000
73# define PLX_LCL_DMA1_IE 0x00080000
74# define PLX_LCL_DOORBELL_INT 0x00100000
75# define PLX_LCL_DMA0_INT 0x00200000
76# define PLX_LCL_DMA1_INT 0x00400000
77# define PLX_LCL_BIST_INT 0x00800000
78# define PLX_BM_DIRECT_ 0x01000000
79# define PLX_BM_DMA0_ 0x02000000
80# define PLX_BM_DMA1_ 0x04000000
81# define PLX_BM_ABORT_ 0x08000000
82# undef PLX_UNUSED /* 0x10000000 */
83# undef PLX_UNUSED /* 0x20000000 */
84# undef PLX_UNUSED /* 0x40000000 */
85# undef PLX_UNUSED /* 0x80000000 */
86
87#define PLX_MISC_CSR 0x6c /* EEPROM,PCI,User,Init Control/Status*/
88# define PLX_USEROUT 0x00010000
89# define PLX_USERIN 0x00020000
90# define PLX_EECK 0x01000000
91# define PLX_EECS 0x02000000
92# define PLX_EEWD 0x04000000
93# define PLX_EERD 0x08000000
94
95/*
96 * DMA registers. Offset is from local side
97 */
98#define PLX_DMA0_MODE 0x100
99# define PLX_DMA_MODE_WIDTH32 0x00000003
100# define PLX_DMA_MODE_WAITSTATES(X) ((X)<<2)
101# define PLX_DMA_MODE_NOREADY 0x00000000
102# define PLX_DMA_MODE_READY 0x00000040
103# define PLX_DMA_MODE_NOBTERM 0x00000000
104# define PLX_DMA_MODE_BTERM 0x00000080
105# define PLX_DMA_MODE_NOBURST 0x00000000
106# define PLX_DMA_MODE_BURST 0x00000100
107# define PLX_DMA_MODE_NOCHAIN 0x00000000
108# define PLX_DMA_MODE_CHAIN 0x00000200
109# define PLX_DMA_MODE_DONE_IE 0x00000400
110# define PLX_DMA_MODE_ADDR_HOLD 0x00000800
111
112#define PLX_DMA0_PCI_ADDR 0x104
113 /* non-chaining mode PCI address */
114
115#define PLX_DMA0_LCL_ADDR 0x108
116 /* non-chaining mode local address */
117
118#define PLX_DMA0_SIZE 0x10C
119 /* non-chaining mode length */
120
121#define PLX_DMA0_DESCRIPTOR 0x110
122# define PLX_DMA_DESC_EOC 0x00000002
123# define PLX_DMA_DESC_TC_IE 0x00000004
124# define PLX_DMA_DESC_TO_HOST 0x00000008
125# define PLX_DMA_DESC_TO_BOARD 0x00000000
126# define PLX_DMA_DESC_NEXTADDR 0xFFFFfff0
127
128#define PLX_DMA1_MODE 0x114
129#define PLX_DMA1_PCI_ADDR 0x118
130#define PLX_DMA1_LCL_ADDR 0x11C
131#define PLX_DMA1_SIZE 0x110
132#define PLX_DMA1_DESCRIPTOR 0x124
133
134#define PLX_DMA_CSR 0x128
135# define PLX_DMA_CSR_0_ENABLE 0x00000001
136# define PLX_DMA_CSR_0_START 0x00000002
137# define PLX_DMA_CSR_0_ABORT 0x00000004
138# define PLX_DMA_CSR_0_CLR_INTR 0x00000008
139# define PLX_DMA_CSR_0_DONE 0x00000010
140# define PLX_DMA_CSR_1_ENABLE 0x00000100
141# define PLX_DMA_CSR_1_START 0x00000200
142# define PLX_DMA_CSR_1_ABORT 0x00000400
143# define PLX_DMA_CSR_1_CLR_INTR 0x00000800
144# define PLX_DMA_CSR_1_DONE 0x00001000
145
146#define PLX_DMA_ARB0 0x12C
147# define PLX_DMA_ARB0_LATENCY_T 0x000000FF
148# define PLX_DMA_ARB0_PAUSE_T 0x0000FF00
149# define PLX_DMA_ARB0_LATENCY_EN 0x00010000
150# define PLX_DMA_ARB0_PAUSE_EN 0x00020000
151# define PLX_DMA_ARB0_BREQ_EN 0x00040000
152# define PLX_DMA_ARB0_PRI 0x00180000
153# define PLX_DMA_ARB0_PRI_ROUND 0x00000000
154# define PLX_DMA_ARB0_PRI_0 0x00080000
155# define PLX_DMA_ARB0_PRI_1 0x00100000
156
157#define PLX_DMA_ARB1 0x130
158 /* Chan 0: FIFO DEPTH=16 */
159# define PLX_DMA_ARB1_0_P2L_LW_TRIG(X) ( ((X)&15) << 0 )
160# define PLX_DMA_ARB1_0_L2P_LR_TRIG(X) ( ((X)&15) << 4 )
161# define PLX_DMA_ARB1_0_L2P_PW_TRIG(X) ( ((X)&15) << 8 )
162# define PLX_DMA_ARB1_0_P2L_PR_TRIG(X) ( ((X)&15) << 12 )
163 /* Chan 1: FIFO DEPTH=8 */
164# define PLX_DMA_ARB1_1_P2L_LW_TRIG(X) ( ((X)& 7) << 16 )
165# define PLX_DMA_ARB1_1_L2P_LR_TRIG(X) ( ((X)& 7) << 20 )
166# define PLX_DMA_ARB1_1_L2P_PW_TRIG(X) ( ((X)& 7) << 24 )
167# define PLX_DMA_ARB1_1_P2L_PR_TRIG(X) ( ((X)& 7) << 28 )
168
169typedef struct _dmachain
170{
171 ulong pciaddr;
172 ulong lcladdr;
173 ulong len;
174 ulong next;
175} DMACHAIN;