| Linus Torvalds | 1da177e | 2005-04-16 15:20:36 -0700 | [diff] [blame^] | 1 | # |
| 2 | # Acorn Network device configuration |
| 3 | # These are for Acorn's Expansion card network interfaces |
| 4 | # |
| 5 | config ARM_AM79C961A |
| 6 | bool "ARM EBSA110 AM79C961A support" |
| 7 | depends on NET_ETHERNET && ARM && ARCH_EBSA110 |
| 8 | select CRC32 |
| 9 | help |
| 10 | If you wish to compile a kernel for the EBSA-110, then you should |
| 11 | always answer Y to this. |
| 12 | |
| 13 | config ARM_ETHER1 |
| 14 | tristate "Acorn Ether1 support" |
| 15 | depends on NET_ETHERNET && ARM && ARCH_ACORN |
| 16 | help |
| 17 | If you have an Acorn system with one of these (AKA25) network cards, |
| 18 | you should say Y to this option if you wish to use it with Linux. |
| 19 | |
| 20 | config ARM_ETHER3 |
| 21 | tristate "Acorn/ANT Ether3 support" |
| 22 | depends on NET_ETHERNET && ARM && ARCH_ACORN |
| 23 | help |
| 24 | If you have an Acorn system with one of these network cards, you |
| 25 | should say Y to this option if you wish to use it with Linux. |
| 26 | |
| 27 | config ARM_ETHERH |
| 28 | tristate "I-cubed EtherH/ANT EtherM support" |
| 29 | depends on NET_ETHERNET && ARM && ARCH_ACORN |
| 30 | select CRC32 |
| 31 | help |
| 32 | If you have an Acorn system with one of these network cards, you |
| 33 | should say Y to this option if you wish to use it with Linux. |
| 34 | |
| 35 | config ARM_ETHER00 |
| 36 | tristate "Altera Ether00 support" |
| 37 | depends on NET_ETHERNET && ARM && ARCH_CAMELOT |
| 38 | help |
| 39 | This is the driver for Altera's ether00 ethernet mac IP core. Say |
| 40 | Y here if you want to build support for this into the kernel. It |
| 41 | is also available as a module (say M here) that can be inserted/ |
| 42 | removed from the kernel at the same time as the PLD is configured. |
| 43 | If this driver is running on an epxa10 development board then it |
| 44 | will generate a suitable hw address based on the board serial |
| 45 | number (MTD support is required for this). Otherwise you will |
| 46 | need to set a suitable hw address using ifconfig. |