blob: 079f7c86726b118c334bfd6f42607a1924e27ee8 [file] [log] [blame]
Linus Torvalds1da177e2005-04-16 15:20:36 -07001/*
2 * IDE tuning and bus mastering support for the CS5510/CS5520
3 * chipsets
4 *
5 * The CS5510/CS5520 are slightly unusual devices. Unlike the
6 * typical IDE controllers they do bus mastering with the drive in
7 * PIO mode and smarter silicon.
8 *
9 * The practical upshot of this is that we must always tune the
10 * drive for the right PIO mode. We must also ignore all the blacklists
11 * and the drive bus mastering DMA information.
12 *
13 * *** This driver is strictly experimental ***
14 *
15 * (c) Copyright Red Hat Inc 2002
16 *
17 * This program is free software; you can redistribute it and/or modify it
18 * under the terms of the GNU General Public License as published by the
19 * Free Software Foundation; either version 2, or (at your option) any
20 * later version.
21 *
22 * This program is distributed in the hope that it will be useful, but
23 * WITHOUT ANY WARRANTY; without even the implied warranty of
24 * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the GNU
25 * General Public License for more details.
26 *
27 * For the avoidance of doubt the "preferred form" of this code is one which
28 * is in an open non patent encumbered format. Where cryptographic key signing
29 * forms part of the process of creating an executable the information
30 * including keys needed to generate an equivalently functional executable
31 * are deemed to be part of the source code.
32 *
33 */
34
Linus Torvalds1da177e2005-04-16 15:20:36 -070035#include <linux/module.h>
36#include <linux/types.h>
37#include <linux/kernel.h>
38#include <linux/delay.h>
39#include <linux/timer.h>
40#include <linux/mm.h>
41#include <linux/ioport.h>
42#include <linux/blkdev.h>
43#include <linux/hdreg.h>
44
45#include <linux/interrupt.h>
46#include <linux/init.h>
47#include <linux/pci.h>
48#include <linux/ide.h>
49#include <linux/dma-mapping.h>
50
51#include <asm/io.h>
52#include <asm/irq.h>
53
54struct pio_clocks
55{
56 int address;
57 int assert;
58 int recovery;
59};
60
61static struct pio_clocks cs5520_pio_clocks[]={
62 {3, 6, 11},
63 {2, 5, 6},
64 {1, 4, 3},
65 {1, 3, 2},
66 {1, 2, 1}
67};
68
69static int cs5520_tune_chipset(ide_drive_t *drive, u8 xferspeed)
70{
71 ide_hwif_t *hwif = HWIF(drive);
72 struct pci_dev *pdev = hwif->pci_dev;
73 u8 speed = min((u8)XFER_PIO_4, xferspeed);
74 int pio = speed;
75 u8 reg;
76 int controller = drive->dn > 1 ? 1 : 0;
77 int error;
78
79 switch(speed)
80 {
81 case XFER_PIO_4:
82 case XFER_PIO_3:
83 case XFER_PIO_2:
84 case XFER_PIO_1:
85 case XFER_PIO_0:
86 pio -= XFER_PIO_0;
87 break;
88 default:
89 pio = 0;
90 printk(KERN_ERR "cs55x0: bad ide timing.\n");
91 }
92
93 printk("PIO clocking = %d\n", pio);
94
95 /* FIXME: if DMA = 1 do we need to set the DMA bit here ? */
96
97 /* 8bit CAT/CRT - 8bit command timing for channel */
98 pci_write_config_byte(pdev, 0x62 + controller,
99 (cs5520_pio_clocks[pio].recovery << 4) |
100 (cs5520_pio_clocks[pio].assert));
101
102 /* 0x64 - 16bit Primary, 0x68 - 16bit Secondary */
103
104 /* FIXME: should these use address ? */
105 /* Data read timing */
106 pci_write_config_byte(pdev, 0x64 + 4*controller + (drive->dn&1),
107 (cs5520_pio_clocks[pio].recovery << 4) |
108 (cs5520_pio_clocks[pio].assert));
109 /* Write command timing */
110 pci_write_config_byte(pdev, 0x66 + 4*controller + (drive->dn&1),
111 (cs5520_pio_clocks[pio].recovery << 4) |
112 (cs5520_pio_clocks[pio].assert));
113
114 /* Set the DMA enable/disable flag */
115 reg = inb(hwif->dma_base + 0x02 + 8*controller);
116 reg |= 1<<((drive->dn&1)+5);
117 outb(reg, hwif->dma_base + 0x02 + 8*controller);
118
119 error = ide_config_drive_speed(drive, speed);
120 /* ATAPI is harder so leave it for now */
121 if(!error && drive->media == ide_disk)
122 error = hwif->ide_dma_on(drive);
123
124 return error;
125}
126
127static void cs5520_tune_drive(ide_drive_t *drive, u8 pio)
128{
129 pio = ide_get_best_pio_mode(drive, pio, 4, NULL);
130 cs5520_tune_chipset(drive, (XFER_PIO_0 + pio));
131}
132
133static int cs5520_config_drive_xfer_rate(ide_drive_t *drive)
134{
135 ide_hwif_t *hwif = HWIF(drive);
136
137 /* Tune the drive for PIO modes up to PIO 4 */
138 cs5520_tune_drive(drive, 4);
139 /* Then tell the core to use DMA operations */
140 return hwif->ide_dma_on(drive);
141}
142
143/*
144 * We provide a callback for our nonstandard DMA location
145 */
146
147static void __devinit cs5520_init_setup_dma(struct pci_dev *dev, ide_pci_device_t *d, ide_hwif_t *hwif)
148{
149 unsigned long bmide = pci_resource_start(dev, 2); /* Not the usual 4 */
150 if(hwif->mate && hwif->mate->dma_base) /* Second channel at primary + 8 */
151 bmide += 8;
152 ide_setup_dma(hwif, bmide, 8);
153}
154
155/*
156 * We wrap the DMA activate to set the vdma flag. This is needed
157 * so that the IDE DMA layer issues PIO not DMA commands over the
158 * DMA channel
159 */
160
161static int cs5520_dma_on(ide_drive_t *drive)
162{
163 drive->vdma = 1;
164 return 0;
165}
166
167static void __devinit init_hwif_cs5520(ide_hwif_t *hwif)
168{
169 hwif->tuneproc = &cs5520_tune_drive;
170 hwif->speedproc = &cs5520_tune_chipset;
171 hwif->ide_dma_check = &cs5520_config_drive_xfer_rate;
172 hwif->ide_dma_on = &cs5520_dma_on;
173
174 if(!noautodma)
175 hwif->autodma = 1;
176
177 if(!hwif->dma_base)
178 {
179 hwif->drives[0].autotune = 1;
180 hwif->drives[1].autotune = 1;
181 return;
182 }
183
184 hwif->atapi_dma = 0;
185 hwif->ultra_mask = 0;
186 hwif->swdma_mask = 0;
187 hwif->mwdma_mask = 0;
188
189 hwif->drives[0].autodma = hwif->autodma;
190 hwif->drives[1].autodma = hwif->autodma;
191}
192
193#define DECLARE_CS_DEV(name_str) \
194 { \
195 .name = name_str, \
196 .init_setup_dma = cs5520_init_setup_dma, \
197 .init_hwif = init_hwif_cs5520, \
198 .channels = 2, \
199 .autodma = AUTODMA, \
200 .bootable = ON_BOARD, \
201 .flags = IDEPCI_FLAG_ISA_PORTS, \
202 }
203
204static ide_pci_device_t cyrix_chipsets[] __devinitdata = {
205 /* 0 */ DECLARE_CS_DEV("Cyrix 5510"),
206 /* 1 */ DECLARE_CS_DEV("Cyrix 5520")
207};
208
209/*
210 * The 5510/5520 are a bit weird. They don't quite set up the way
211 * the PCI helper layer expects so we must do much of the set up
212 * work longhand.
213 */
214
215static int __devinit cs5520_init_one(struct pci_dev *dev, const struct pci_device_id *id)
216{
217 ata_index_t index;
218 ide_pci_device_t *d = &cyrix_chipsets[id->driver_data];
219
220 ide_setup_pci_noise(dev, d);
221
222 /* We must not grab the entire device, it has 'ISA' space in its
223 BARS too and we will freak out other bits of the kernel */
Amit Gud1e39dea2005-11-18 23:03:19 +0100224 if (pci_enable_device_bars(dev, 1<<2)) {
Linus Torvalds1da177e2005-04-16 15:20:36 -0700225 printk(KERN_WARNING "%s: Unable to enable 55x0.\n", d->name);
Amit Gud1e39dea2005-11-18 23:03:19 +0100226 return -ENODEV;
Linus Torvalds1da177e2005-04-16 15:20:36 -0700227 }
228 pci_set_master(dev);
229 if (pci_set_dma_mask(dev, DMA_32BIT_MASK)) {
230 printk(KERN_WARNING "cs5520: No suitable DMA available.\n");
231 return -ENODEV;
232 }
233
234 index.all = 0xf0f0;
235
236 /*
237 * Now the chipset is configured we can let the core
238 * do all the device setup for us
239 */
240
241 ide_pci_setup_ports(dev, d, 14, &index);
242
243 if((index.b.low & 0xf0) != 0xf0)
244 probe_hwif_init(&ide_hwifs[index.b.low]);
245 if((index.b.high & 0xf0) != 0xf0)
246 probe_hwif_init(&ide_hwifs[index.b.high]);
247 return 0;
248}
249
250static struct pci_device_id cs5520_pci_tbl[] = {
251 { PCI_VENDOR_ID_CYRIX, PCI_DEVICE_ID_CYRIX_5510, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0},
252 { PCI_VENDOR_ID_CYRIX, PCI_DEVICE_ID_CYRIX_5520, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 1},
253 { 0, },
254};
255MODULE_DEVICE_TABLE(pci, cs5520_pci_tbl);
256
257static struct pci_driver driver = {
258 .name = "Cyrix_IDE",
259 .id_table = cs5520_pci_tbl,
260 .probe = cs5520_init_one,
261};
262
263static int cs5520_ide_init(void)
264{
265 return ide_pci_register_driver(&driver);
266}
267
268module_init(cs5520_ide_init);
269
270MODULE_AUTHOR("Alan Cox");
271MODULE_DESCRIPTION("PCI driver module for Cyrix 5510/5520 IDE");
272MODULE_LICENSE("GPL");