drivers/gpu/drm/gma500/cdv_intel_crt.c

/*
 * Copyright © 2006-2007 Intel Corporation
 *
 * Permission is hereby granted, free of charge, to any person obtaining a
 * copy of this software and associated documentation files (the "Software"),
 * to deal in the Software without restriction, including without limitation
 * the rights to use, copy, modify, merge, publish, distribute, sublicense,
 * and/or sell copies of the Software, and to permit persons to whom the
 * Software is furnished to do so, subject to the following conditions:
 *
 * The above copyright notice and this permission notice (including the next
 * paragraph) shall be included in all copies or substantial portions of the
 * Software.
 *
 * THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR
 * IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY,
 * FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT.  IN NO EVENT SHALL
 * THE AUTHORS OR COPYRIGHT HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER
 * LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING
 * FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR OTHER
 * DEALINGS IN THE SOFTWARE.
 *
 * Authors:
 *	Eric Anholt <eric@anholt.net>
 */

#include <linux/i2c.h>
#include <drm/drmP.h>

#include "intel_bios.h"
#include "psb_drv.h"
#include "psb_intel_drv.h"
#include "psb_intel_reg.h"
#include "power.h"
#include "cdv_device.h"
#include <linux/pm_runtime.h>


static void cdv_intel_crt_dpms(struct drm_encoder *encoder, int mode)
{
	struct drm_device *dev = encoder->dev;
	u32 temp, reg;
	reg = ADPA;

	temp = REG_READ(reg);
	temp &= ~(ADPA_HSYNC_CNTL_DISABLE | ADPA_VSYNC_CNTL_DISABLE);
	temp &= ~ADPA_DAC_ENABLE;

	switch (mode) {
	case DRM_MODE_DPMS_ON:
		temp |= ADPA_DAC_ENABLE;
		break;
	case DRM_MODE_DPMS_STANDBY:
		temp |= ADPA_DAC_ENABLE | ADPA_HSYNC_CNTL_DISABLE;
		break;
	case DRM_MODE_DPMS_SUSPEND:
		temp |= ADPA_DAC_ENABLE | ADPA_VSYNC_CNTL_DISABLE;
		break;
	case DRM_MODE_DPMS_OFF:
		temp |= ADPA_HSYNC_CNTL_DISABLE | ADPA_VSYNC_CNTL_DISABLE;
		break;
	}

	REG_WRITE(reg, temp);
}

static int cdv_intel_crt_mode_valid(struct drm_connector *connector,
				struct drm_display_mode *mode)
{
	if (mode->flags & DRM_MODE_FLAG_DBLSCAN)
		return MODE_NO_DBLESCAN;

	/* The lowest clock for CDV is 20000KHz */
	if (mode->clock < 20000)
		return MODE_CLOCK_LOW;

	/* The max clock for CDV is 355 instead of 400 */
	if (mode->clock > 355000)
		return MODE_CLOCK_HIGH;

	return MODE_OK;
}

static void cdv_intel_crt_mode_set(struct drm_encoder *encoder,
			       struct drm_display_mode *mode,
			       struct drm_display_mode *adjusted_mode)
{

	struct drm_device *dev = encoder->dev;
	struct drm_crtc *crtc = encoder->crtc;
	struct gma_crtc *gma_crtc = to_gma_crtc(crtc);
	int dpll_md_reg;
	u32 adpa, dpll_md;
	u32 adpa_reg;

	if (gma_crtc->pipe == 0)
		dpll_md_reg = DPLL_A_MD;
	else
		dpll_md_reg = DPLL_B_MD;

	adpa_reg = ADPA;

	/*
	 * Disable separate mode multiplier used when cloning SDVO to CRT
	 * XXX this needs to be adjusted when we really are cloning
	 */
	{
		dpll_md = REG_READ(dpll_md_reg);
		REG_WRITE(dpll_md_reg,
			   dpll_md & ~DPLL_MD_UDI_MULTIPLIER_MASK);
	}

	adpa = 0;
	if (adjusted_mode->flags & DRM_MODE_FLAG_PHSYNC)
		adpa |= ADPA_HSYNC_ACTIVE_HIGH;
	if (adjusted_mode->flags & DRM_MODE_FLAG_PVSYNC)
		adpa |= ADPA_VSYNC_ACTIVE_HIGH;

	if (gma_crtc->pipe == 0)
		adpa |= ADPA_PIPE_A_SELECT;
	else
		adpa |= ADPA_PIPE_B_SELECT;

	REG_WRITE(adpa_reg, adpa);
}


/**
 * Uses CRT_HOTPLUG_EN and CRT_HOTPLUG_STAT to detect CRT presence.
 *
 * \return true if CRT is connected.
 * \return false if CRT is disconnected.
 */
static bool cdv_intel_crt_detect_hotplug(struct drm_connector *connector,
								bool force)
{
	struct drm_device *dev = connector->dev;
	u32 hotplug_en;
	int i, tries = 0, ret = false;
	u32 orig;

	/*
	 * On a CDV thep, CRT detect sequence need to be done twice
	 * to get a reliable result.
	 */
	tries = 2;

	orig = hotplug_en = REG_READ(PORT_HOTPLUG_EN);
	hotplug_en &= ~(CRT_HOTPLUG_DETECT_MASK);
	hotplug_en |= CRT_HOTPLUG_FORCE_DETECT;

	hotplug_en |= CRT_HOTPLUG_ACTIVATION_PERIOD_64;
	hotplug_en |= CRT_HOTPLUG_VOLTAGE_COMPARE_50;

	for (i = 0; i < tries ; i++) {
		unsigned long timeout;
		/* turn on the FORCE_DETECT */
		REG_WRITE(PORT_HOTPLUG_EN, hotplug_en);
		timeout = jiffies + msecs_to_jiffies(1000);
		/* wait for FORCE_DETECT to go off */
		do {
			if (!(REG_READ(PORT_HOTPLUG_EN) &
					CRT_HOTPLUG_FORCE_DETECT))
				break;
			msleep(1);
		} while (time_after(timeout, jiffies));
	}

	if ((REG_READ(PORT_HOTPLUG_STAT) & CRT_HOTPLUG_MONITOR_MASK) !=
	    CRT_HOTPLUG_MONITOR_NONE)
		ret = true;

	 /* clear the interrupt we just generated, if any */
	REG_WRITE(PORT_HOTPLUG_STAT, CRT_HOTPLUG_INT_STATUS);

	/* and put the bits back */
	REG_WRITE(PORT_HOTPLUG_EN, orig);
	return ret;
}

static enum drm_connector_status cdv_intel_crt_detect(
				struct drm_connector *connector, bool force)
{
	if (cdv_intel_crt_detect_hotplug(connector, force))
		return connector_status_connected;
	else
		return connector_status_disconnected;
}

static void cdv_intel_crt_destroy(struct drm_connector *connector)
{
	struct gma_encoder *gma_encoder = gma_attached_encoder(connector);

	psb_intel_i2c_destroy(gma_encoder->ddc_bus);
	drm_connector_unregister(connector);
	drm_connector_cleanup(connector);
	kfree(connector);
}

static int cdv_intel_crt_get_modes(struct drm_connector *connector)
{
	struct gma_encoder *gma_encoder = gma_attached_encoder(connector);
	return psb_intel_ddc_get_modes(connector,
				       &gma_encoder->ddc_bus->adapter);
}

static int cdv_intel_crt_set_property(struct drm_connector *connector,
				  struct drm_property *property,
				  uint64_t value)
{
	return 0;
}

/*
 * Routines for controlling stuff on the analog port
 */

static const struct drm_encoder_helper_funcs cdv_intel_crt_helper_funcs = {
	.dpms = cdv_intel_crt_dpms,
	.mode_fixup = gma_encoder_mode_fixup,
	.prepare = gma_encoder_prepare,
	.commit = gma_encoder_commit,
	.mode_set = cdv_intel_crt_mode_set,
};

static const struct drm_connector_funcs cdv_intel_crt_connector_funcs = {
	.dpms = drm_helper_connector_dpms,
	.detect = cdv_intel_crt_detect,
	.fill_modes = drm_helper_probe_single_connector_modes,
	.destroy = cdv_intel_crt_destroy,
	.set_property = cdv_intel_crt_set_property,
};

static const struct drm_connector_helper_funcs
				cdv_intel_crt_connector_helper_funcs = {
	.mode_valid = cdv_intel_crt_mode_valid,
	.get_modes = cdv_intel_crt_get_modes,
	.best_encoder = gma_best_encoder,
};

static void cdv_intel_crt_enc_destroy(struct drm_encoder *encoder)
{
	drm_encoder_cleanup(encoder);
}

static const struct drm_encoder_funcs cdv_intel_crt_enc_funcs = {
	.destroy = cdv_intel_crt_enc_destroy,
};

void cdv_intel_crt_init(struct drm_device *dev,
			struct psb_intel_mode_device *mode_dev)
{

	struct gma_connector *gma_connector;
	struct gma_encoder *gma_encoder;
	struct drm_connector *connector;
	struct drm_encoder *encoder;

	u32 i2c_reg;

	gma_encoder = kzalloc(sizeof(struct gma_encoder), GFP_KERNEL);
	if (!gma_encoder)
		return;

	gma_connector = kzalloc(sizeof(struct gma_connector), GFP_KERNEL);
	if (!gma_connector)
		goto failed_connector;

	connector = &gma_connector->base;
	connector->polled = DRM_CONNECTOR_POLL_HPD;
	drm_connector_init(dev, connector,
		&cdv_intel_crt_connector_funcs, DRM_MODE_CONNECTOR_VGA);

	encoder = &gma_encoder->base;
	drm_encoder_init(dev, encoder,
		&cdv_intel_crt_enc_funcs, DRM_MODE_ENCODER_DAC);

	gma_connector_attach_encoder(gma_connector, gma_encoder);

	/* Set up the DDC bus. */
	i2c_reg = GPIOA;
	/* Remove the following code for CDV */
	/*
	if (dev_priv->crt_ddc_bus != 0)
		i2c_reg = dev_priv->crt_ddc_bus;
	}*/
	gma_encoder->ddc_bus = psb_intel_i2c_create(dev,
							  i2c_reg, "CRTDDC_A");
	if (!gma_encoder->ddc_bus) {
		dev_printk(KERN_ERR, &dev->pdev->dev, "DDC bus registration "
			   "failed.\n");
		goto failed_ddc;
	}

	gma_encoder->type = INTEL_OUTPUT_ANALOG;
	/*
	psb_intel_output->clone_mask = (1 << INTEL_ANALOG_CLONE_BIT);
	psb_intel_output->crtc_mask = (1 << 0) | (1 << 1);
	*/
	connector->interlace_allowed = 0;
	connector->doublescan_allowed = 0;

	drm_encoder_helper_add(encoder, &cdv_intel_crt_helper_funcs);
	drm_connector_helper_add(connector,
					&cdv_intel_crt_connector_helper_funcs);

	drm_connector_register(connector);

	return;
failed_ddc:
	drm_encoder_cleanup(&gma_encoder->base);
	drm_connector_cleanup(&gma_connector->base);
	kfree(gma_connector);
failed_connector:
	kfree(gma_encoder);
	return;
}