blob: bb76c667a476557df0416a43f2ad622247fbd65c [file] [log] [blame]
Ramkrishna Vepa5adfb642009-04-01 18:14:23 +00001Neterion's (Formerly S2io) X3100 Series 10GbE PCIe Server Adapter Linux driver
2==============================================================================
3
4Contents
5--------
6
71) Introduction
82) Features supported
93) Configurable driver parameters
104) Troubleshooting
11
121) Introduction:
13----------------
14This Linux driver supports all Neterion's X3100 series 10 GbE PCIe I/O
15Virtualized Server adapters.
16The X3100 series supports four modes of operation, configurable via
17firmware -
18 Single function mode
19 Multi function mode
20 SRIOV mode
21 MRIOV mode
22The functions share a 10GbE link and the pci-e bus, but hardly anything else
23inside the ASIC. Features like independent hw reset, statistics, bandwidth/
24priority allocation and guarantees, GRO, TSO, interrupt moderation etc are
25supported independently on each function.
26
27(See below for a complete list of features supported for both IPv4 and IPv6)
28
292) Features supported:
30----------------------
31
32i) Single function mode (up to 17 queues)
33
34ii) Multi function mode (up to 17 functions)
35
36iii) PCI-SIG's I/O Virtualization
37 - Single Root mode: v1.0 (up to 17 functions)
38 - Multi-Root mode: v1.0 (up to 17 functions)
39
40iv) Jumbo frames
41 X3100 Series supports MTU up to 9600 bytes, modifiable using
42 ifconfig command.
43
44v) Offloads supported: (Enabled by default)
45 Checksum offload (TCP/UDP/IP) on transmit and receive paths
46 TCP Segmentation Offload (TSO) on transmit path
47 Generic Receive Offload (GRO) on receive path
48
49vi) MSI-X: (Enabled by default)
50 Resulting in noticeable performance improvement (up to 7% on certain
51 platforms).
52
53vii) NAPI: (Enabled by default)
54 For better Rx interrupt moderation.
55
56viii)RTH (Receive Traffic Hash): (Enabled by default)
57 Receive side steering for better scaling.
58
59ix) Statistics
60 Comprehensive MAC-level and software statistics displayed using
61 "ethtool -S" option.
62
63x) Multiple hardware queues: (Enabled by default)
64 Up to 17 hardware based transmit and receive data channels, with
65 multiple steering options (transmit multiqueue enabled by default).
66
673) Configurable driver parameters:
68----------------------------------
69
70i) max_config_dev
71 Specifies maximum device functions to be enabled.
72 Valid range: 1-8
73
74ii) max_config_port
75 Specifies number of ports to be enabled.
76 Valid range: 1,2
77 Default: 1
78
79iii)max_config_vpath
80 Specifies maximum VPATH(s) configured for each device function.
81 Valid range: 1-17
82
83iv) vlan_tag_strip
84 Enables/disables vlan tag stripping from all received tagged frames that
85 are not replicated at the internal L2 switch.
86 Valid range: 0,1 (disabled, enabled respectively)
87 Default: 1
88
89v) addr_learn_en
90 Enable learning the mac address of the guest OS interface in
91 virtualization environment.
92 Valid range: 0,1 (disabled, enabled respectively)
93 Default: 0