blob: f00c02a13ed687be66a2c876dff0ceffa421b621 [file] [log] [blame]
Linus Torvalds1da177e2005-04-16 15:20:36 -07001#
2# FC4 device configuration
3#
4
5menu "Fibre Channel support"
6
7config FC4
8 tristate "Fibre Channel and FC4 SCSI support"
9 ---help---
10 Fibre Channel is a high speed serial protocol mainly used to
11 connect large storage devices to the computer; it is compatible with
12 and intended to replace SCSI.
13
14 This is an experimental support for storage arrays connected to your
15 computer using optical fibre cables and the "X3.269-199X Fibre
16 Channel Protocol for SCSI" specification. If you want to use this,
17 you need to say Y here and to "SCSI support" as well as to the
18 drivers for the storage array itself and for the interface adapter
19 such as SOC or SOC+. This subsystem could even serve for IP
20 networking, with some code extensions.
21
22 If unsure, say N.
23
24comment "FC4 drivers"
25 depends on FC4
26
27config FC4_SOC
28 tristate "Sun SOC/Sbus"
29 depends on FC4!=n && (SPARC32 || SPARC64)
30 help
31 Serial Optical Channel is an interface card with one or two Fibre
32 Optic ports, each of which can be connected to a disk array. Note
33 that if you have older firmware in the card, you'll need the
34 microcode from the Solaris driver to make it work.
35
36 To compile this support as a module, choose M here: the module will
37 be called soc.
38
39config FC4_SOCAL
40 tristate "Sun SOC+ (aka SOCAL)"
41 depends on FC4!=n && (SPARC32 || SPARC64)
42 ---help---
43 Serial Optical Channel Plus is an interface card with up to two
44 Fibre Optic ports. This card supports FC Arbitrated Loop (usually
45 A5000 or internal FC disks in E[3-6]000 machines through the
46 Interface Board). You'll probably need the microcode from the
47 Solaris driver to make it work.
48
49 To compile this support as a module, choose M here: the module will
50 be called socal.
51
52comment "FC4 targets"
53 depends on FC4
54
55config SCSI_PLUTO
56 tristate "SparcSTORAGE Array 100 and 200 series"
57 depends on FC4!=n && SCSI
58 help
59 If you never bought a disk array made by Sun, go with N.
60
61 To compile this support as a module, choose M here: the module will
62 be called pluto.
63
64config SCSI_FCAL
65 tristate "Sun Enterprise Network Array (A5000 and EX500)" if SPARC32 || SPARC64
66 depends on FC4!=n && SCSI
67 help
68 This driver drives FC-AL disks connected through a Fibre Channel
69 card using the drivers/fc4 layer (currently only SOCAL). The most
70 common is either A5000 array or internal disks in E[3-6]000
71 machines.
72
73 To compile this support as a module, choose M here: the module will
74 be called fcal.
75
76config SCSI_FCAL
77 prompt "Generic FC-AL disk driver"
78 depends on FC4!=n && SCSI && !SPARC32 && !SPARC64
79
80endmenu
81