blob: 85898995b234edc244b589415fd2c3391d8cd62d [file] [log] [blame]
Linus Torvalds1da177e2005-04-16 15:20:36 -07001/*
2 * Linux ARCnet driver - COM20020 chipset support - function declarations
3 *
4 * Written 1997 by David Woodhouse.
5 * Written 1994-1999 by Avery Pennarun.
6 * Derived from skeleton.c by Donald Becker.
7 *
8 * Special thanks to Contemporary Controls, Inc. (www.ccontrols.com)
9 * for sponsoring the further development of this driver.
10 *
11 * **********************
12 *
13 * The original copyright of skeleton.c was as follows:
14 *
15 * skeleton.c Written 1993 by Donald Becker.
16 * Copyright 1993 United States Government as represented by the
17 * Director, National Security Agency. This software may only be used
18 * and distributed according to the terms of the GNU General Public License as
19 * modified by SRC, incorporated herein by reference.
20 *
21 * **********************
22 *
23 * For more details, see drivers/net/arcnet.c
24 *
25 * **********************
26 */
27#ifndef __COM20020_H
28#define __COM20020_H
29
30int com20020_check(struct net_device *dev);
31int com20020_found(struct net_device *dev, int shared);
David S. Miller0db155d2009-01-23 22:28:48 -080032extern const struct net_device_ops com20020_netdev_ops;
Linus Torvalds1da177e2005-04-16 15:20:36 -070033
34/* The number of low I/O ports used by the card. */
35#define ARCNET_TOTAL_SIZE 8
36
37/* various register addresses */
38#ifdef CONFIG_SA1100_CT6001
39#define BUS_ALIGN 2 /* 8 bit device on a 16 bit bus - needs padding */
40#else
41#define BUS_ALIGN 1
42#endif
43
Michael Grzeschikc51da422014-09-29 11:55:37 +020044#define PLX_PCI_MAX_CARDS 2
Michael Grzeschik8c14f9c2014-09-29 11:55:36 +020045
46struct com20020_pci_channel_map {
47 u32 bar;
48 u32 offset;
49 u32 size; /* 0x00 - auto, e.g. length of entire bar */
50};
51
52struct com20020_pci_card_info {
53 const char *name;
54 int devcount;
55
56 struct com20020_pci_channel_map chan_map_tbl[PLX_PCI_MAX_CARDS];
57
58 unsigned int flags;
59};
Linus Torvalds1da177e2005-04-16 15:20:36 -070060
Michael Grzeschikc51da422014-09-29 11:55:37 +020061struct com20020_priv {
62 struct com20020_pci_card_info *ci;
63 struct list_head list_dev;
64};
65
66struct com20020_dev {
67 struct list_head list;
68 struct net_device *dev;
69
70 struct com20020_priv *pci_priv;
71 int index;
72};
73
Linus Torvalds1da177e2005-04-16 15:20:36 -070074#define _INTMASK (ioaddr+BUS_ALIGN*0) /* writable */
75#define _STATUS (ioaddr+BUS_ALIGN*0) /* readable */
76#define _COMMAND (ioaddr+BUS_ALIGN*1) /* standard arcnet commands */
77#define _DIAGSTAT (ioaddr+BUS_ALIGN*1) /* diagnostic status register */
78#define _ADDR_HI (ioaddr+BUS_ALIGN*2) /* control registers for IO-mapped memory */
79#define _ADDR_LO (ioaddr+BUS_ALIGN*3)
80#define _MEMDATA (ioaddr+BUS_ALIGN*4) /* data port for IO-mapped memory */
81#define _SUBADR (ioaddr+BUS_ALIGN*5) /* the extended port _XREG refers to */
82#define _CONFIG (ioaddr+BUS_ALIGN*6) /* configuration register */
83#define _XREG (ioaddr+BUS_ALIGN*7) /* extra registers (indexed by _CONFIG
84 or _SUBADR) */
85
86/* in the ADDR_HI register */
87#define RDDATAflag 0x80 /* next access is a read (not a write) */
88
89/* in the DIAGSTAT register */
90#define NEWNXTIDflag 0x02 /* ID to which token is passed has changed */
91
92/* in the CONFIG register */
93#define RESETcfg 0x80 /* put card in reset state */
94#define TXENcfg 0x20 /* enable TX */
95
96/* in SETUP register */
97#define PROMISCset 0x10 /* enable RCV_ALL */
98#define P1MODE 0x80 /* enable P1-MODE for Backplane */
99#define SLOWARB 0x01 /* enable Slow Arbitration for >=5Mbps */
100
101/* COM2002x */
102#define SUB_TENTATIVE 0 /* tentative node ID */
103#define SUB_NODE 1 /* node ID */
104#define SUB_SETUP1 2 /* various options */
105#define SUB_TEST 3 /* test/diag register */
106
107/* COM20022 only */
108#define SUB_SETUP2 4 /* sundry options */
109#define SUB_BUSCTL 5 /* bus control options */
110#define SUB_DMACOUNT 6 /* DMA count options */
111
112#define SET_SUBADR(x) do { \
113 if ((x) < 4) \
114 { \
115 lp->config = (lp->config & ~0x03) | (x); \
116 SETCONF; \
117 } \
118 else \
119 { \
120 outb(x, _SUBADR); \
121 } \
122} while (0)
123
124#undef ARCRESET
125#undef ASTATUS
126#undef ACOMMAND
127#undef AINTMASK
128
129#define ARCRESET { outb(lp->config | 0x80, _CONFIG); \
130 udelay(5); \
131 outb(lp->config , _CONFIG); \
132 }
133#define ARCRESET0 { outb(0x18 | 0x80, _CONFIG); \
134 udelay(5); \
135 outb(0x18 , _CONFIG); \
136 }
137
138#define ASTATUS() inb(_STATUS)
139#define ADIAGSTATUS() inb(_DIAGSTAT)
140#define ACOMMAND(cmd) outb((cmd),_COMMAND)
141#define AINTMASK(msk) outb((msk),_INTMASK)
142
143#define SETCONF outb(lp->config, _CONFIG)
144
145#endif /* __COM20020_H */