blob: 7cb1273202cc6adbf97ea60c83d0abf8425e3bdb [file] [log] [blame]
Linus Torvalds1da177e2005-04-16 15:20:36 -07001/*======================================================================
2
3 Device driver for the PCMCIA control functionality of StrongARM
4 SA-1100 microprocessors.
5
6 The contents of this file are subject to the Mozilla Public
7 License Version 1.1 (the "License"); you may not use this file
8 except in compliance with the License. You may obtain a copy of
9 the License at http://www.mozilla.org/MPL/
10
11 Software distributed under the License is distributed on an "AS
12 IS" basis, WITHOUT WARRANTY OF ANY KIND, either express or
13 implied. See the License for the specific language governing
14 rights and limitations under the License.
15
16 The initial developer of the original code is John G. Dorsey
17 <john+@cs.cmu.edu>. Portions created by John G. Dorsey are
18 Copyright (C) 1999 John G. Dorsey. All Rights Reserved.
19
20 Alternatively, the contents of this file may be used under the
21 terms of the GNU Public License version 2 (the "GPL"), in which
22 case the provisions of the GPL are applicable instead of the
23 above. If you wish to allow the use of your version of this file
24 only under the terms of the GPL and not to allow others to use
25 your version of this file under the MPL, indicate your decision
26 by deleting the provisions above and replace them with the notice
27 and other provisions required by the GPL. If you do not delete
28 the provisions above, a recipient may use your version of this
29 file under either the MPL or the GPL.
30
31======================================================================*/
32
33#include <linux/module.h>
34#include <linux/init.h>
Linus Torvalds1da177e2005-04-16 15:20:36 -070035#include <linux/cpufreq.h>
36#include <linux/ioport.h>
37#include <linux/kernel.h>
38#include <linux/spinlock.h>
39
Russell Kinga09e64f2008-08-05 16:14:15 +010040#include <mach/hardware.h>
Linus Torvalds1da177e2005-04-16 15:20:36 -070041#include <asm/io.h>
42#include <asm/irq.h>
43#include <asm/system.h>
44
45#include "soc_common.h"
46#include "sa11xx_base.h"
47
48
49/*
50 * sa1100_pcmcia_default_mecr_timing
51 * ^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
52 *
53 * Calculate MECR clock wait states for given CPU clock
54 * speed and command wait state. This function can be over-
55 * written by a board specific version.
56 *
57 * The default is to simply calculate the BS values as specified in
58 * the INTEL SA1100 development manual
59 * "Expansion Memory (PCMCIA) Configuration Register (MECR)"
60 * that's section 10.2.5 in _my_ version of the manual ;)
61 */
62static unsigned int
63sa1100_pcmcia_default_mecr_timing(struct soc_pcmcia_socket *skt,
64 unsigned int cpu_speed,
65 unsigned int cmd_time)
66{
67 return sa1100_pcmcia_mecr_bs(cmd_time, cpu_speed);
68}
69
70/* sa1100_pcmcia_set_mecr()
71 * ^^^^^^^^^^^^^^^^^^^^^^^^
72 *
73 * set MECR value for socket <sock> based on this sockets
74 * io, mem and attribute space access speed.
75 * Call board specific BS value calculation to allow boards
76 * to tweak the BS values.
77 */
78static int
79sa1100_pcmcia_set_mecr(struct soc_pcmcia_socket *skt, unsigned int cpu_clock)
80{
81 struct soc_pcmcia_timing timing;
82 u32 mecr, old_mecr;
83 unsigned long flags;
84 unsigned int bs_io, bs_mem, bs_attr;
85
86 soc_common_pcmcia_get_timing(skt, &timing);
87
88 bs_io = skt->ops->get_timing(skt, cpu_clock, timing.io);
89 bs_mem = skt->ops->get_timing(skt, cpu_clock, timing.mem);
90 bs_attr = skt->ops->get_timing(skt, cpu_clock, timing.attr);
91
92 local_irq_save(flags);
93
94 old_mecr = mecr = MECR;
95 MECR_FAST_SET(mecr, skt->nr, 0);
96 MECR_BSIO_SET(mecr, skt->nr, bs_io);
97 MECR_BSA_SET(mecr, skt->nr, bs_attr);
98 MECR_BSM_SET(mecr, skt->nr, bs_mem);
99 if (old_mecr != mecr)
100 MECR = mecr;
101
102 local_irq_restore(flags);
103
104 debug(skt, 2, "FAST %X BSM %X BSA %X BSIO %X\n",
105 MECR_FAST_GET(mecr, skt->nr),
106 MECR_BSM_GET(mecr, skt->nr), MECR_BSA_GET(mecr, skt->nr),
107 MECR_BSIO_GET(mecr, skt->nr));
108
109 return 0;
110}
111
112#ifdef CONFIG_CPU_FREQ
113static int
114sa1100_pcmcia_frequency_change(struct soc_pcmcia_socket *skt,
115 unsigned long val,
116 struct cpufreq_freqs *freqs)
117{
118 switch (val) {
119 case CPUFREQ_PRECHANGE:
120 if (freqs->new > freqs->old)
121 sa1100_pcmcia_set_mecr(skt, freqs->new);
122 break;
123
124 case CPUFREQ_POSTCHANGE:
125 if (freqs->new < freqs->old)
126 sa1100_pcmcia_set_mecr(skt, freqs->new);
127 break;
128 case CPUFREQ_RESUMECHANGE:
129 sa1100_pcmcia_set_mecr(skt, freqs->new);
130 break;
131 }
132
133 return 0;
134}
135
136#endif
137
138static int
139sa1100_pcmcia_set_timing(struct soc_pcmcia_socket *skt)
140{
141 return sa1100_pcmcia_set_mecr(skt, cpufreq_get(0));
142}
143
144static int
145sa1100_pcmcia_show_timing(struct soc_pcmcia_socket *skt, char *buf)
146{
147 struct soc_pcmcia_timing timing;
148 unsigned int clock = cpufreq_get(0);
149 unsigned long mecr = MECR;
150 char *p = buf;
151
152 soc_common_pcmcia_get_timing(skt, &timing);
153
154 p+=sprintf(p, "I/O : %u (%u)\n", timing.io,
155 sa1100_pcmcia_cmd_time(clock, MECR_BSIO_GET(mecr, skt->nr)));
156
157 p+=sprintf(p, "attribute: %u (%u)\n", timing.attr,
158 sa1100_pcmcia_cmd_time(clock, MECR_BSA_GET(mecr, skt->nr)));
159
160 p+=sprintf(p, "common : %u (%u)\n", timing.mem,
161 sa1100_pcmcia_cmd_time(clock, MECR_BSM_GET(mecr, skt->nr)));
162
163 return p - buf;
164}
165
166int sa11xx_drv_pcmcia_probe(struct device *dev, struct pcmcia_low_level *ops,
167 int first, int nr)
168{
169 /*
170 * set default MECR calculation if the board specific
171 * code did not specify one...
172 */
173 if (!ops->get_timing)
174 ops->get_timing = sa1100_pcmcia_default_mecr_timing;
175
176 /* Provide our SA11x0 specific timing routines. */
177 ops->set_timing = sa1100_pcmcia_set_timing;
178 ops->show_timing = sa1100_pcmcia_show_timing;
179#ifdef CONFIG_CPU_FREQ
180 ops->frequency_change = sa1100_pcmcia_frequency_change;
181#endif
182
183 return soc_common_drv_pcmcia_probe(dev, ops, first, nr);
184}
185EXPORT_SYMBOL(sa11xx_drv_pcmcia_probe);
186
187static int __init sa11xx_pcmcia_init(void)
188{
189 return 0;
190}
Richard Purdief36598ae2005-09-03 19:39:25 +0100191fs_initcall(sa11xx_pcmcia_init);
Linus Torvalds1da177e2005-04-16 15:20:36 -0700192
193static void __exit sa11xx_pcmcia_exit(void) {}
194
195module_exit(sa11xx_pcmcia_exit);
196
197MODULE_AUTHOR("John Dorsey <john+@cs.cmu.edu>");
198MODULE_DESCRIPTION("Linux PCMCIA Card Services: SA-11xx core socket driver");
199MODULE_LICENSE("Dual MPL/GPL");