lib/zlib_inflate/inffast.c

/* inffast.c -- fast decoding
 * Copyright (C) 1995-2004 Mark Adler
 * For conditions of distribution and use, see copyright notice in zlib.h
 */

#include <linux/zutil.h>
#include "inftrees.h"
#include "inflate.h"
#include "inffast.h"

#ifndef ASMINF

/* Allow machine dependent optimization for post-increment or pre-increment.
   Based on testing to date,
   Pre-increment preferred for:
   - PowerPC G3 (Adler)
   - MIPS R5000 (Randers-Pehrson)
   Post-increment preferred for:
   - none
   No measurable difference:
   - Pentium III (Anderson)
   - M68060 (Nikl)
 */
#ifdef POSTINC
#  define OFF 0
#  define PUP(a) *(a)++
#else
#  define OFF 1
#  define PUP(a) *++(a)
#endif

/*
   Decode literal, length, and distance codes and write out the resulting
   literal and match bytes until either not enough input or output is
   available, an end-of-block is encountered, or a data error is encountered.
   When large enough input and output buffers are supplied to inflate(), for
   example, a 16K input buffer and a 64K output buffer, more than 95% of the
   inflate execution time is spent in this routine.

   Entry assumptions:

        state->mode == LEN
        strm->avail_in >= 6
        strm->avail_out >= 258
        start >= strm->avail_out
        state->bits < 8

   On return, state->mode is one of:

        LEN -- ran out of enough output space or enough available input
        TYPE -- reached end of block code, inflate() to interpret next block
        BAD -- error in block data

   Notes:

    - The maximum input bits used by a length/distance pair is 15 bits for the
      length code, 5 bits for the length extra, 15 bits for the distance code,
      and 13 bits for the distance extra.  This totals 48 bits, or six bytes.
      Therefore if strm->avail_in >= 6, then there is enough input to avoid
      checking for available input while decoding.

    - The maximum bytes that a single length/distance pair can output is 258
      bytes, which is the maximum length that can be coded.  inflate_fast()
      requires strm->avail_out >= 258 for each loop to avoid checking for
      output space.

    - @start:	inflate()'s starting value for strm->avail_out
 */
void inflate_fast(z_streamp strm, unsigned start)
{
    struct inflate_state *state;
    unsigned char *in;      /* local strm->next_in */
    unsigned char *last;    /* while in < last, enough input available */
    unsigned char *out;     /* local strm->next_out */
    unsigned char *beg;     /* inflate()'s initial strm->next_out */
    unsigned char *end;     /* while out < end, enough space available */
#ifdef INFLATE_STRICT
    unsigned dmax;              /* maximum distance from zlib header */
#endif
    unsigned wsize;             /* window size or zero if not using window */
    unsigned whave;             /* valid bytes in the window */
    unsigned write;             /* window write index */
    unsigned char *window;  /* allocated sliding window, if wsize != 0 */
    unsigned long hold;         /* local strm->hold */
    unsigned bits;              /* local strm->bits */
    code const *lcode;      /* local strm->lencode */
    code const *dcode;      /* local strm->distcode */
    unsigned lmask;             /* mask for first level of length codes */
    unsigned dmask;             /* mask for first level of distance codes */
    code this;                  /* retrieved table entry */
    unsigned op;                /* code bits, operation, extra bits, or */
                                /*  window position, window bytes to copy */
    unsigned len;               /* match length, unused bytes */
    unsigned dist;              /* match distance */
    unsigned char *from;    /* where to copy match from */

    /* copy state to local variables */
    state = (struct inflate_state *)strm->state;
    in = strm->next_in - OFF;
    last = in + (strm->avail_in - 5);
    out = strm->next_out - OFF;
    beg = out - (start - strm->avail_out);
    end = out + (strm->avail_out - 257);
#ifdef INFLATE_STRICT
    dmax = state->dmax;
#endif
    wsize = state->wsize;
    whave = state->whave;
    write = state->write;
    window = state->window;
    hold = state->hold;
    bits = state->bits;
    lcode = state->lencode;
    dcode = state->distcode;
    lmask = (1U << state->lenbits) - 1;
    dmask = (1U << state->distbits) - 1;

    /* decode literals and length/distances until end-of-block or not enough
       input data or output space */
    do {
        if (bits < 15) {
            hold += (unsigned long)(PUP(in)) << bits;
            bits += 8;
            hold += (unsigned long)(PUP(in)) << bits;
            bits += 8;
        }
        this = lcode[hold & lmask];
      dolen:
        op = (unsigned)(this.bits);
        hold >>= op;
        bits -= op;
        op = (unsigned)(this.op);
        if (op == 0) {                          /* literal */
            PUP(out) = (unsigned char)(this.val);
        }
        else if (op & 16) {                     /* length base */
            len = (unsigned)(this.val);
            op &= 15;                           /* number of extra bits */
            if (op) {
                if (bits < op) {
                    hold += (unsigned long)(PUP(in)) << bits;
                    bits += 8;
                }
                len += (unsigned)hold & ((1U << op) - 1);
                hold >>= op;
                bits -= op;
            }
            if (bits < 15) {
                hold += (unsigned long)(PUP(in)) << bits;
                bits += 8;
                hold += (unsigned long)(PUP(in)) << bits;
                bits += 8;
            }
            this = dcode[hold & dmask];
          dodist:
            op = (unsigned)(this.bits);
            hold >>= op;
            bits -= op;
            op = (unsigned)(this.op);
            if (op & 16) {                      /* distance base */
                dist = (unsigned)(this.val);
                op &= 15;                       /* number of extra bits */
                if (bits < op) {
                    hold += (unsigned long)(PUP(in)) << bits;
                    bits += 8;
                    if (bits < op) {
                        hold += (unsigned long)(PUP(in)) << bits;
                        bits += 8;
                    }
                }
                dist += (unsigned)hold & ((1U << op) - 1);
#ifdef INFLATE_STRICT
                if (dist > dmax) {
                    strm->msg = (char *)"invalid distance too far back";
                    state->mode = BAD;
                    break;
                }
#endif
                hold >>= op;
                bits -= op;
                op = (unsigned)(out - beg);     /* max distance in output */
                if (dist > op) {                /* see if copy from window */
                    op = dist - op;             /* distance back in window */
                    if (op > whave) {
                        strm->msg = (char *)"invalid distance too far back";
                        state->mode = BAD;
                        break;
                    }
                    from = window - OFF;
                    if (write == 0) {           /* very common case */
                        from += wsize - op;
                        if (op < len) {         /* some from window */
                            len -= op;
                            do {
                                PUP(out) = PUP(from);
                            } while (--op);
                            from = out - dist;  /* rest from output */
                        }
                    }
                    else if (write < op) {      /* wrap around window */
                        from += wsize + write - op;
                        op -= write;
                        if (op < len) {         /* some from end of window */
                            len -= op;
                            do {
                                PUP(out) = PUP(from);
                            } while (--op);
                            from = window - OFF;
                            if (write < len) {  /* some from start of window */
                                op = write;
                                len -= op;
                                do {
                                    PUP(out) = PUP(from);
                                } while (--op);
                                from = out - dist;      /* rest from output */
                            }
                        }
                    }
                    else {                      /* contiguous in window */
                        from += write - op;
                        if (op < len) {         /* some from window */
                            len -= op;
                            do {
                                PUP(out) = PUP(from);
                            } while (--op);
                            from = out - dist;  /* rest from output */
                        }
                    }
                    while (len > 2) {
                        PUP(out) = PUP(from);
                        PUP(out) = PUP(from);
                        PUP(out) = PUP(from);
                        len -= 3;
                    }
                    if (len) {
                        PUP(out) = PUP(from);
                        if (len > 1)
                            PUP(out) = PUP(from);
                    }
                }
                else {
                    from = out - dist;          /* copy direct from output */
                    do {                        /* minimum length is three */
                        PUP(out) = PUP(from);
                        PUP(out) = PUP(from);
                        PUP(out) = PUP(from);
                        len -= 3;
                    } while (len > 2);
                    if (len) {
                        PUP(out) = PUP(from);
                        if (len > 1)
                            PUP(out) = PUP(from);
                    }
                }
            }
            else if ((op & 64) == 0) {          /* 2nd level distance code */
                this = dcode[this.val + (hold & ((1U << op) - 1))];
                goto dodist;
            }
            else {
                strm->msg = (char *)"invalid distance code";
                state->mode = BAD;
                break;
            }
        }
        else if ((op & 64) == 0) {              /* 2nd level length code */
            this = lcode[this.val + (hold & ((1U << op) - 1))];
            goto dolen;
        }
        else if (op & 32) {                     /* end-of-block */
            state->mode = TYPE;
            break;
        }
        else {
            strm->msg = (char *)"invalid literal/length code";
            state->mode = BAD;
            break;
        }
    } while (in < last && out < end);

    /* return unused bytes (on entry, bits < 8, so in won't go too far back) */
    len = bits >> 3;
    in -= len;
    bits -= len << 3;
    hold &= (1U << bits) - 1;

    /* update state and return */
    strm->next_in = in + OFF;
    strm->next_out = out + OFF;
    strm->avail_in = (unsigned)(in < last ? 5 + (last - in) : 5 - (in - last));
    strm->avail_out = (unsigned)(out < end ?
                                 257 + (end - out) : 257 - (out - end));
    state->hold = hold;
    state->bits = bits;
    return;
}

/*
   inflate_fast() speedups that turned out slower (on a PowerPC G3 750CXe):
   - Using bit fields for code structure
   - Different op definition to avoid & for extra bits (do & for table bits)
   - Three separate decoding do-loops for direct, window, and write == 0
   - Special case for distance > 1 copies to do overlapped load and store copy
   - Explicit branch predictions (based on measured branch probabilities)
   - Deferring match copy and interspersed it with decoding subsequent codes
   - Swapping literal/length else
   - Swapping window/direct else
   - Larger unrolled copy loops (three is about right)
   - Moving len -= 3 statement into middle of loop
 */

#endif /* !ASMINF */