| Linus Walleij | 9a01be1 | 2012-03-06 21:15:51 +0100 | [diff] [blame] | 1 | /* |
| 2 | * Standard pin control state definitions |
| 3 | */ |
| 4 | |
| Linus Walleij | 65697e6 | 2012-05-07 11:17:53 +0200 | [diff] [blame] | 5 | /** |
| 6 | * @PINCTRL_STATE_DEFAULT: the state the pinctrl handle shall be put |
| 7 | * into as default, usually this means the pins are up and ready to |
| 8 | * be used by the device driver. This state is commonly used by |
| Linus Walleij | b0e181d | 2012-09-26 14:59:47 +0200 | [diff] [blame] | 9 | * hogs to configure muxing and pins at boot, and also as a state |
| 10 | * to go into when returning from sleep and idle in |
| 11 | * .pm_runtime_resume() or ordinary .resume() for example. |
| Linus Walleij | 65697e6 | 2012-05-07 11:17:53 +0200 | [diff] [blame] | 12 | * @PINCTRL_STATE_IDLE: the state the pinctrl handle shall be put into |
| Linus Walleij | b0e181d | 2012-09-26 14:59:47 +0200 | [diff] [blame] | 13 | * when the pins are idle. This is a state where the system is relaxed |
| 14 | * but not fully sleeping - some power may be on but clocks gated for |
| 15 | * example. Could typically be set from a pm_runtime_suspend() or |
| 16 | * pm_runtime_idle() operation. |
| Linus Walleij | 65697e6 | 2012-05-07 11:17:53 +0200 | [diff] [blame] | 17 | * @PINCTRL_STATE_SLEEP: the state the pinctrl handle shall be put into |
| Linus Walleij | b0e181d | 2012-09-26 14:59:47 +0200 | [diff] [blame] | 18 | * when the pins are sleeping. This is a state where the system is in |
| 19 | * its lowest sleep state. Could typically be set from an |
| 20 | * ordinary .suspend() function. |
| Linus Walleij | 65697e6 | 2012-05-07 11:17:53 +0200 | [diff] [blame] | 21 | */ |
| Linus Walleij | 9a01be1 | 2012-03-06 21:15:51 +0100 | [diff] [blame] | 22 | #define PINCTRL_STATE_DEFAULT "default" |
| 23 | #define PINCTRL_STATE_IDLE "idle" |
| Linus Walleij | 65697e6 | 2012-05-07 11:17:53 +0200 | [diff] [blame] | 24 | #define PINCTRL_STATE_SLEEP "sleep" |