blob: cc50bd09aa26cc584f6359c857e345366365b714 [file] [log] [blame]
Alan Cox51dbd492007-11-19 14:45:53 +00001/*
2 * pata_ninja32.c - Ninja32 PATA for new ATA layer
3 * (C) 2007 Red Hat Inc
Alan Cox51dbd492007-11-19 14:45:53 +00004 *
5 * Note: The controller like many controllers has shared timings for
6 * PIO and DMA. We thus flip to the DMA timings in dma_start and flip back
7 * in the dma_stop function. Thus we actually don't need a set_dmamode
8 * method as the PIO method is always called and will set the right PIO
9 * timing parameters.
10 *
11 * The Ninja32 Cardbus is not a generic SFF controller. Instead it is
12 * laid out as follows off BAR 0. This is based upon Mark Lord's delkin
13 * driver and the extensive analysis done by the BSD developers, notably
14 * ITOH Yasufumi.
15 *
16 * Base + 0x00 IRQ Status
17 * Base + 0x01 IRQ control
18 * Base + 0x02 Chipset control
Alan Cox41946452008-02-08 15:25:10 +000019 * Base + 0x03 Unknown
Alan Cox51dbd492007-11-19 14:45:53 +000020 * Base + 0x04 VDMA and reset control + wait bits
21 * Base + 0x08 BMIMBA
22 * Base + 0x0C DMA Length
23 * Base + 0x10 Taskfile
24 * Base + 0x18 BMDMA Status ?
25 * Base + 0x1C
26 * Base + 0x1D Bus master control
27 * bit 0 = enable
28 * bit 1 = 0 write/1 read
29 * bit 2 = 1 sgtable
30 * bit 3 = go
31 * bit 4-6 wait bits
32 * bit 7 = done
33 * Base + 0x1E AltStatus
34 * Base + 0x1F timing register
35 */
36
37#include <linux/kernel.h>
38#include <linux/module.h>
39#include <linux/pci.h>
40#include <linux/init.h>
41#include <linux/blkdev.h>
42#include <linux/delay.h>
43#include <scsi/scsi_host.h>
44#include <linux/libata.h>
45
46#define DRV_NAME "pata_ninja32"
Alan Coxe3cf95d2009-04-09 17:31:17 +010047#define DRV_VERSION "0.1.5"
Alan Cox51dbd492007-11-19 14:45:53 +000048
49
50/**
51 * ninja32_set_piomode - set initial PIO mode data
52 * @ap: ATA interface
53 * @adev: ATA device
54 *
55 * Called to do the PIO mode setup. Our timing registers are shared
56 * but we want to set the PIO timing by default.
57 */
58
59static void ninja32_set_piomode(struct ata_port *ap, struct ata_device *adev)
60{
61 static u16 pio_timing[5] = {
62 0xd6, 0x85, 0x44, 0x33, 0x13
63 };
Jeff Garzik11b7bec2007-11-23 21:12:14 -050064 iowrite8(pio_timing[adev->pio_mode - XFER_PIO_0],
65 ap->ioaddr.bmdma_addr + 0x1f);
Alan Cox51dbd492007-11-19 14:45:53 +000066 ap->private_data = adev;
67}
68
69
70static void ninja32_dev_select(struct ata_port *ap, unsigned int device)
71{
72 struct ata_device *adev = &ap->link.device[device];
73 if (ap->private_data != adev) {
74 iowrite8(0xd6, ap->ioaddr.bmdma_addr + 0x1f);
Tejun Heo9363c382008-04-07 22:47:16 +090075 ata_sff_dev_select(ap, device);
Alan Cox51dbd492007-11-19 14:45:53 +000076 ninja32_set_piomode(ap, adev);
77 }
78}
79
80static struct scsi_host_template ninja32_sht = {
Tejun Heo68d1d072008-03-25 12:22:49 +090081 ATA_BMDMA_SHT(DRV_NAME),
Alan Cox51dbd492007-11-19 14:45:53 +000082};
83
84static struct ata_port_operations ninja32_port_ops = {
Tejun Heo029cfd62008-03-25 12:22:49 +090085 .inherits = &ata_bmdma_port_ops,
Tejun Heo5682ed32008-04-07 22:47:16 +090086 .sff_dev_select = ninja32_dev_select,
Alan Cox51dbd492007-11-19 14:45:53 +000087 .cable_detect = ata_cable_40wire,
Tejun Heo029cfd62008-03-25 12:22:49 +090088 .set_piomode = ninja32_set_piomode,
Alan Coxe3cf95d2009-04-09 17:31:17 +010089 .sff_data_xfer = ata_sff_data_xfer32
Alan Cox51dbd492007-11-19 14:45:53 +000090};
91
Alan Coxe7c0d212008-10-17 19:08:31 +010092static void ninja32_program(void __iomem *base)
93{
94 iowrite8(0x05, base + 0x01); /* Enable interrupt lines */
95 iowrite8(0xBE, base + 0x02); /* Burst, ?? setup */
96 iowrite8(0x01, base + 0x03); /* Unknown */
97 iowrite8(0x20, base + 0x04); /* WAIT0 */
98 iowrite8(0x8f, base + 0x05); /* Unknown */
99 iowrite8(0xa4, base + 0x1c); /* Unknown */
100 iowrite8(0x83, base + 0x1d); /* BMDMA control: WAIT0 */
101}
102
Alan Cox51dbd492007-11-19 14:45:53 +0000103static int ninja32_init_one(struct pci_dev *dev, const struct pci_device_id *id)
104{
105 struct ata_host *host;
106 struct ata_port *ap;
107 void __iomem *base;
108 int rc;
109
110 host = ata_host_alloc(&dev->dev, 1);
111 if (!host)
112 return -ENOMEM;
113 ap = host->ports[0];
114
115 /* Set up the PCI device */
116 rc = pcim_enable_device(dev);
117 if (rc)
118 return rc;
119 rc = pcim_iomap_regions(dev, 1 << 0, DRV_NAME);
120 if (rc == -EBUSY)
121 pcim_pin_device(dev);
122 if (rc)
123 return rc;
124
125 host->iomap = pcim_iomap_table(dev);
126 rc = pci_set_dma_mask(dev, ATA_DMA_MASK);
127 if (rc)
128 return rc;
129 rc = pci_set_consistent_dma_mask(dev, ATA_DMA_MASK);
130 if (rc)
131 return rc;
132 pci_set_master(dev);
133
Alan Coxb6049582008-12-05 19:42:38 +0000134 /* Set up the register mappings. We use the I/O mapping as only the
135 older chips also have MMIO on BAR 1 */
Alan Cox51dbd492007-11-19 14:45:53 +0000136 base = host->iomap[0];
137 if (!base)
138 return -ENOMEM;
139 ap->ops = &ninja32_port_ops;
Erik Inge Bolsø14bdef92009-03-14 21:38:24 +0100140 ap->pio_mask = ATA_PIO4;
Alan Cox51dbd492007-11-19 14:45:53 +0000141 ap->flags |= ATA_FLAG_SLAVE_POSS;
142
143 ap->ioaddr.cmd_addr = base + 0x10;
144 ap->ioaddr.ctl_addr = base + 0x1E;
145 ap->ioaddr.altstatus_addr = base + 0x1E;
146 ap->ioaddr.bmdma_addr = base;
Tejun Heo9363c382008-04-07 22:47:16 +0900147 ata_sff_std_ports(&ap->ioaddr);
Alan Coxe3cf95d2009-04-09 17:31:17 +0100148 ap->pflags = ATA_PFLAG_PIO32 | ATA_PFLAG_PIO32CHANGE;
Alan Cox51dbd492007-11-19 14:45:53 +0000149
Alan Coxe7c0d212008-10-17 19:08:31 +0100150 ninja32_program(base);
Alan Cox51dbd492007-11-19 14:45:53 +0000151 /* FIXME: Should we disable them at remove ? */
Tejun Heoc3b28892010-05-19 22:10:21 +0200152 return ata_host_activate(host, dev->irq, ata_bmdma_interrupt,
Jeff Garzik11b7bec2007-11-23 21:12:14 -0500153 IRQF_SHARED, &ninja32_sht);
Alan Cox51dbd492007-11-19 14:45:53 +0000154}
155
Alan Coxe7c0d212008-10-17 19:08:31 +0100156#ifdef CONFIG_PM
157
158static int ninja32_reinit_one(struct pci_dev *pdev)
159{
160 struct ata_host *host = dev_get_drvdata(&pdev->dev);
161 int rc;
162
163 rc = ata_pci_device_do_resume(pdev);
164 if (rc)
165 return rc;
166 ninja32_program(host->iomap[0]);
167 ata_host_resume(host);
168 return 0;
169}
170#endif
171
Alan Cox51dbd492007-11-19 14:45:53 +0000172static const struct pci_device_id ninja32[] = {
Alan Coxb6049582008-12-05 19:42:38 +0000173 { 0x10FC, 0x0003, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0 },
174 { 0x1145, 0x8008, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0 },
175 { 0x1145, 0xf008, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0 },
Jeff Garzik11b7bec2007-11-23 21:12:14 -0500176 { 0x1145, 0xf021, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0 },
177 { 0x1145, 0xf024, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0 },
Alan Coxb6049582008-12-05 19:42:38 +0000178 { 0x1145, 0xf02C, PCI_ANY_ID, PCI_ANY_ID, 0, 0, 0 },
Alan Cox51dbd492007-11-19 14:45:53 +0000179 { },
180};
181
182static struct pci_driver ninja32_pci_driver = {
183 .name = DRV_NAME,
184 .id_table = ninja32,
185 .probe = ninja32_init_one,
Alan Coxe7c0d212008-10-17 19:08:31 +0100186 .remove = ata_pci_remove_one,
187#ifdef CONFIG_PM
188 .suspend = ata_pci_device_suspend,
189 .resume = ninja32_reinit_one,
190#endif
Alan Cox51dbd492007-11-19 14:45:53 +0000191};
192
193static int __init ninja32_init(void)
194{
195 return pci_register_driver(&ninja32_pci_driver);
196}
197
198static void __exit ninja32_exit(void)
199{
200 pci_unregister_driver(&ninja32_pci_driver);
201}
202
203MODULE_AUTHOR("Alan Cox");
204MODULE_DESCRIPTION("low-level driver for Ninja32 ATA");
205MODULE_LICENSE("GPL");
206MODULE_DEVICE_TABLE(pci, ninja32);
207MODULE_VERSION(DRV_VERSION);
208
209module_init(ninja32_init);
210module_exit(ninja32_exit);