blob: 37414146258d8b1b273c15f67bc9c60bf9c3205a [file] [log] [blame]
Linus Torvalds1da177e2005-04-16 15:20:36 -07001/* $Linux: hydra.h,v 1.0 1994/10/26 02:03:47 cgd Exp $ */
2
3/*
4 * Copyright (c) 1994 Timo Rossi
5 * All rights reserved.
6 *
7 * Redistribution and use in source and binary forms, with or without
8 * modification, are permitted provided that the following conditions
9 * are met:
10 * 1. Redistributions of source code must retain the above copyright
11 * notice, this list of conditions and the following disclaimer.
12 * 2. Redistributions in binary form must reproduce the above copyright
13 * notice, this list of conditions and the following disclaimer in the
14 * documentation and/or other materials provided with the distribution.
15 * 3. All advertising materials mentioning features or use of this software
16 * must display the following acknowledgement:
17 * This product includes software developed by Timo Rossi
18 * 4. The name of the author may not be used to endorse or promote products
19 * derived from this software without specific prior written permission
20 *
21 * THIS SOFTWARE IS PROVIDED BY THE AUTHOR ``AS IS'' AND ANY EXPRESS OR
22 * IMPLIED WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES
23 * OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED.
24 * IN NO EVENT SHALL THE AUTHOR BE LIABLE FOR ANY DIRECT, INDIRECT,
25 * INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT
26 * NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
27 * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
28 * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
29 * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE OF
30 * THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
31 */
32
33/*
34 * The Hydra Systems card uses the National Semiconductor
35 * 8390 NIC (Network Interface Controller) chip, located
36 * at card base address + 0xffe1. NIC registers are accessible
37 * only at odd byte addresses, so the register offsets must
38 * be multiplied by two.
39 *
40 * Card address PROM is located at card base + 0xffc0 (even byte addresses)
41 *
42 * RAM starts at the card base address, and is 16K or 64K.
43 * The current Amiga NetBSD hydra driver is hardwired for 16K.
44 * It seems that the RAM should be accessed as words or longwords only.
45 *
46 */
47
48/* adapted for Linux by Topi Kanerva 03/29/95
49 with original author's permission */
50
51#define HYDRA_NIC_BASE 0xffe1
52
53/* Page0 registers */
54
55#define NIC_CR 0 /* Command register */
56#define NIC_PSTART (1*2) /* Page start (write) */
57#define NIC_PSTOP (2*2) /* Page stop (write) */
58#define NIC_BNDRY (3*2) /* Boundary pointer */
59#define NIC_TSR (4*2) /* Transmit status (read) */
60#define NIC_TPSR (4*2) /* Transmit page start (write) */
61#define NIC_NCR (5*2) /* Number of collisions, read */
62#define NIC_TBCR0 (5*2) /* Transmit byte count low (write) */
63#define NIC_FIFO (6*2) /* FIFO reg. (read) */
64#define NIC_TBCR1 (6*2) /* Transmit byte count high (write) */
65#define NIC_ISR (7*2) /* Interrupt status register */
66#define NIC_RBCR0 (0xa*2) /* Remote byte count low (write) */
67#define NIC_RBCR1 (0xb*2) /* Remote byte count high (write) */
68#define NIC_RSR (0xc*2) /* Receive status (read) */
69#define NIC_RCR (0xc*2) /* Receive config (write) */
70#define NIC_CNTR0 (0xd*2) /* Frame alignment error count (read) */
71#define NIC_TCR (0xd*2) /* Transmit config (write) */
72#define NIC_CNTR1 (0xe*2) /* CRC error counter (read) */
73#define NIC_DCR (0xe*2) /* Data config (write) */
74#define NIC_CNTR2 (0xf*2) /* missed packet counter (read) */
75#define NIC_IMR (0xf*2) /* Interrupt mask reg. (write) */
76
77/* Page1 registers */
78
79#define NIC_PAR0 (1*2) /* Physical address */
80#define NIC_PAR1 (2*2)
81#define NIC_PAR2 (3*2)
82#define NIC_PAR3 (4*2)
83#define NIC_PAR4 (5*2)
84#define NIC_PAR5 (6*2)
85#define NIC_CURR (7*2) /* Current RX ring-buffer page */
86#define NIC_MAR0 (8*2) /* Multicast address */
87#define NIC_MAR1 (9*2)
88#define NIC_MAR2 (0xa*2)
89#define NIC_MAR3 (0xb*2)
90#define NIC_MAR4 (0xc*2)
91#define NIC_MAR5 (0xd*2)
92#define NIC_MAR6 (0xe*2)
93#define NIC_MAR7 (0xf*2)
94
95/* Command register definitions */
96
97#define CR_STOP 0x01 /* Stop -- software reset command */
98#define CR_START 0x02 /* Start */
99#define CR_TXP 0x04 /* Transmit packet */
100
101#define CR_RD0 0x08 /* Remote DMA cmd */
102#define CR_RD1 0x10
103#define CR_RD2 0x20
104
105#define CR_NODMA CR_RD2
106
107#define CR_PS0 0x40 /* Page select */
108#define CR_PS1 0x80
109
110#define CR_PAGE0 0
111#define CR_PAGE1 CR_PS0
112#define CR_PAGE2 CR_PS1
113
114/* Interrupt status reg. definitions */
115
116#define ISR_PRX 0x01 /* Packet received without errors */
117#define ISR_PTX 0x02 /* Packet transmitted without errors */
118#define ISR_RXE 0x04 /* Receive error */
119#define ISR_TXE 0x08 /* Transmit error */
120#define ISR_OVW 0x10 /* Ring buffer overrun */
121#define ISR_CNT 0x20 /* Counter overflow */
122#define ISR_RDC 0x40 /* Remote DMA compile */
123#define ISR_RST 0x80 /* Reset status */
124
125/* Data config reg. definitions */
126
127#define DCR_WTS 0x01 /* Word transfer select */
128#define DCR_BOS 0x02 /* Byte order select */
129#define DCR_LAS 0x04 /* Long address select */
130#define DCR_LS 0x08 /* Loopback select */
131#define DCR_AR 0x10 /* Auto-init remote */
132#define DCR_FT0 0x20 /* FIFO threshold select */
133#define DCR_FT1 0x40
134
135/* Transmit config reg. definitions */
136
137#define TCR_CRC 0x01 /* Inhibit CRC */
138#define TCR_LB0 0x02 /* Loopback control */
139#define TCR_LB1 0x04
140#define TCR_ATD 0x08 /* Auto transmit disable */
141#define TCR_OFST 0x10 /* Collision offset enable */
142
143/* Transmit status reg. definitions */
144
145#define TSR_PTX 0x01 /* Packet transmitted */
146#define TSR_COL 0x04 /* Transmit collided */
147#define TSR_ABT 0x08 /* Transmit aborted */
148#define TSR_CRS 0x10 /* Carrier sense lost */
149#define TSR_FU 0x20 /* FIFO underrun */
150#define TSR_CDH 0x40 /* CD Heartbeat */
151#define TSR_OWC 0x80 /* Out of Window Collision */
152
153/* Receiver config register definitions */
154
155#define RCR_SEP 0x01 /* Save errored packets */
156#define RCR_AR 0x02 /* Accept runt packets */
157#define RCR_AB 0x04 /* Accept broadcast */
158#define RCR_AM 0x08 /* Accept multicast */
159#define RCR_PRO 0x10 /* Promiscuous mode */
160#define RCR_MON 0x20 /* Monitor mode */
161
162/* Receiver status register definitions */
163
164#define RSR_PRX 0x01 /* Packet received without error */
165#define RSR_CRC 0x02 /* CRC error */
166#define RSR_FAE 0x04 /* Frame alignment error */
167#define RSR_FO 0x08 /* FIFO overrun */
168#define RSR_MPA 0x10 /* Missed packet */
169#define RSR_PHY 0x20 /* Physical address */
170#define RSR_DIS 0x40 /* Received disabled */
171#define RSR_DFR 0x80 /* Deferring (jabber) */
172
173/* Hydra System card address PROM offset */
174
175#define HYDRA_ADDRPROM 0xffc0
176
177