avr32: Power Management support ("standby" and "mem" modes)
Implement Standby support. In this mode, we'll suspend all drivers,
put the SDRAM in self-refresh mode and switch off the HSB bus
("frozen" mode.)
Implement Suspend-to-mem support. In this mode, we suspend all
drivers, put the SDRAM into self-refresh mode and switch off all
internal clocks except the 32 kHz oscillator ("stop" mode.)
The lowest-level suspend code runs from a small portion of SRAM
allocated at startup time. This gets rid of a small potential race
with the SDRAM where we might try to enter self-refresh mode in the
middle of an icache burst. We also relocate all interrupt and
exception handlers to SRAM during the small window when we enter and
exit the low-power modes.
We don't need to do any special tricks to start and stop the PLL. The
main clock is automatically gated by hardware until the PLL is stable.
Signed-off-by: Haavard Skinnemoen <hskinnemoen@atmel.com>
diff --git a/include/asm-avr32/thread_info.h b/include/asm-avr32/thread_info.h
index 07049f6..df68631 100644
--- a/include/asm-avr32/thread_info.h
+++ b/include/asm-avr32/thread_info.h
@@ -88,6 +88,7 @@
#define TIF_MEMDIE 6
#define TIF_RESTORE_SIGMASK 7 /* restore signal mask in do_signal */
#define TIF_CPU_GOING_TO_SLEEP 8 /* CPU is entering sleep 0 mode */
+#define TIF_FREEZE 29
#define TIF_DEBUG 30 /* debugging enabled */
#define TIF_USERSPACE 31 /* true if FS sets userspace */