drivers: net: stmmac: add port selection programming
In case of SGMII more, for example when a MAC2MAC connection
is needed, the port selection bits (inside the MAC configuration
registers) have to be programmed according to the link selected.
So the patch adds a new DT parameter to pass the port selection
and to programmed related PCS and CORE to use it.
Signed-off-by: Giuseppe Cavallaro <peppe.cavallaro@st.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
index 6142fce..aab777c 100644
--- a/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
+++ b/drivers/net/ethernet/stmicro/stmmac/stmmac_main.c
@@ -1666,6 +1666,19 @@
if (priv->plat->bus_setup)
priv->plat->bus_setup(priv->ioaddr);
+ /* PS and related bits will be programmed according to the speed */
+ if (priv->hw->pcs) {
+ int speed = priv->plat->mac_port_sel_speed;
+
+ if ((speed == SPEED_10) || (speed == SPEED_100) ||
+ (speed == SPEED_1000)) {
+ priv->hw->ps = speed;
+ } else {
+ dev_warn(priv->device, "invalid port speed\n");
+ priv->hw->ps = 0;
+ }
+ }
+
/* Initialize the MAC Core */
priv->hw->mac->core_init(priv->hw, dev->mtu);
@@ -1716,7 +1729,7 @@
}
if (priv->hw->pcs && priv->hw->mac->pcs_ctrl_ane)
- priv->hw->mac->pcs_ctrl_ane(priv->hw, 1, 0, 0);
+ priv->hw->mac->pcs_ctrl_ane(priv->hw, 1, priv->hw->ps, 0);
/* set TX ring length */
if (priv->hw->dma->set_tx_ring_len)