spi: davinci: add additional comments
Add comments describing the platform data members
and per-chip-select SPI configuration structure.
Also, add some comments describing the what happens
during the driver probe.
Signed-off-by: Brian Niebuhr <bniebuhr@efjohnson.com>
Tested-By: Michael Williamson <michael.williamson@criticallink.com>
Signed-off-by: Sekhar Nori <nsekhar@ti.com>
diff --git a/arch/arm/mach-davinci/include/mach/spi.h b/arch/arm/mach-davinci/include/mach/spi.h
index 1f8b786..38f4da5 100644
--- a/arch/arm/mach-davinci/include/mach/spi.h
+++ b/arch/arm/mach-davinci/include/mach/spi.h
@@ -26,6 +26,20 @@
SPI_VERSION_2, /* For DA8xx */
};
+/**
+ * davinci_spi_platform_data - Platform data for SPI master device on DaVinci
+ *
+ * @version: version of the SPI IP. Different DaVinci devices have slightly
+ * varying versions of the same IP.
+ * @num_chipselect: number of chipselects supported by this SPI master
+ * @intr_line: interrupt line used to connect the SPI IP to the ARM interrupt
+ * controller withn the SoC. Possible values are 0 and 1.
+ * @chip_sel: list of GPIOs which can act as chip-selects for the SPI.
+ * SPI_INTERN_CS denotes internal SPI chip-select. Not necessary
+ * to populate if all chip-selects are internal.
+ * @cshold_bug: set this to true if the SPI controller on your chip requires
+ * a write to CSHOLD bit in between transfers (like in DM355).
+ */
struct davinci_spi_platform_data {
u8 version;
u8 num_chipselect;
@@ -34,6 +48,24 @@
bool cshold_bug;
};
+/**
+ * davinci_spi_config - Per-chip-select configuration for SPI slave devices
+ *
+ * @wdelay: amount of delay between transmissions. Measured in number of
+ * SPI module clocks.
+ * @odd_parity: polarity of parity flag at the end of transmit data stream.
+ * 0 - odd parity, 1 - even parity.
+ * @parity_enable: enable transmission of parity at end of each transmit
+ * data stream.
+ * @io_type: type of IO transfer. Choose between polled, interrupt and DMA.
+ * @timer_disable: disable chip-select timers (setup and hold)
+ * @c2tdelay: chip-select setup time. Measured in number of SPI module clocks.
+ * @t2cdelay: chip-select hold time. Measured in number of SPI module clocks.
+ * @t2edelay: transmit data finished to SPI ENAn pin inactive time. Measured
+ * in number of SPI clocks.
+ * @c2edelay: chip-select active to SPI ENAn signal active time. Measured in
+ * number of SPI clocks.
+ */
struct davinci_spi_config {
u8 wdelay;
u8 odd_parity;