gpio/lynxpoint: check if the interrupt is enabled in IRQ handler
Checking LP_INT_STAT is not enough in the interrupt handler because its
contents get updated regardless of whether the pin has interrupt enabled or
not. This causes the driver to loop forever for GPIOs that are pulled up.
Fix this by checking the interrupt enable bit for the pin as well.
Cc: stable@vger.kernel.org
Signed-off-by: Mika Westerberg <mika.westerberg@linux.intel.com>
Acked-by: Mathias Nyman <mathias.nyman@linux.intel.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/gpio/gpio-lynxpoint.c b/drivers/gpio/gpio-lynxpoint.c
index 2d9ca60..41b5913 100644
--- a/drivers/gpio/gpio-lynxpoint.c
+++ b/drivers/gpio/gpio-lynxpoint.c
@@ -248,14 +248,15 @@
struct lp_gpio *lg = irq_data_get_irq_handler_data(data);
struct irq_chip *chip = irq_data_get_irq_chip(data);
u32 base, pin, mask;
- unsigned long reg, pending;
+ unsigned long reg, ena, pending;
unsigned virq;
/* check from GPIO controller which pin triggered the interrupt */
for (base = 0; base < lg->chip.ngpio; base += 32) {
reg = lp_gpio_reg(&lg->chip, base, LP_INT_STAT);
+ ena = lp_gpio_reg(&lg->chip, base, LP_INT_ENABLE);
- while ((pending = inl(reg))) {
+ while ((pending = (inl(reg) & inl(ena)))) {
pin = __ffs(pending);
mask = BIT(pin);
/* Clear before handling so we don't lose an edge */