pinctrl: add abx500 pinctrl driver core
This adds the AB8500 core driver, which will be utilized by
the follow-on drivers for different ABx500 variants.
Sselect the driver from the DBX500_SOC, as this chip is
powering and clocking that SoC.
Cc: Samuel Ortiz <sameo@linux.intel.com>
Signed-off-by: Patrice Chotard <patrice.chotard@st.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/arch/arm/mach-ux500/board-mop500.c b/arch/arm/mach-ux500/board-mop500.c
index d453522..b6f14ee 100644
--- a/arch/arm/mach-ux500/board-mop500.c
+++ b/arch/arm/mach-ux500/board-mop500.c
@@ -90,26 +90,9 @@
},
};
-static struct ab8500_gpio_platform_data ab8500_gpio_pdata = {
+static struct abx500_gpio_platform_data ab8500_gpio_pdata = {
.gpio_base = MOP500_AB8500_PIN_GPIO(1),
.irq_base = MOP500_AB8500_VIR_GPIO_IRQ_BASE,
- /* config_reg is the initial configuration of ab8500 pins.
- * The pins can be configured as GPIO or alt functions based
- * on value present in GpioSel1 to GpioSel6 and AlternatFunction
- * register. This is the array of 7 configuration settings.
- * One has to compile time decide these settings. Below is the
- * explanation of these setting
- * GpioSel1 = 0x00 => Pins GPIO1 to GPIO8 are not used as GPIO
- * GpioSel2 = 0x1E => Pins GPIO10 to GPIO13 are configured as GPIO
- * GpioSel3 = 0x80 => Pin GPIO24 is configured as GPIO
- * GpioSel4 = 0x01 => Pin GPIo25 is configured as GPIO
- * GpioSel5 = 0x7A => Pins GPIO34, GPIO36 to GPIO39 are conf as GPIO
- * GpioSel6 = 0x00 => Pins GPIO41 & GPIo42 are not configured as GPIO
- * AlternaFunction = 0x00 => If Pins GPIO10 to 13 are not configured
- * as GPIO then this register selectes the alternate fucntions
- */
- .config_reg = {0x00, 0x1E, 0x80, 0x01,
- 0x7A, 0x00, 0x00},
};
/* ab8500-codec */