spi/gpio: start with CS non-active
The chip select line was configured as output with the initial value
being active explicitly. It was later deasserted during
spi_bitbang_setup() without any clock activity in between. So it makes
no sense to activate the device at all and the chip select line can
better start non-active.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@pengutronix.de>
Acked-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
diff --git a/drivers/spi/spi-gpio.c b/drivers/spi/spi-gpio.c
index 0094c645..0b56cfc7 100644
--- a/drivers/spi/spi-gpio.c
+++ b/drivers/spi/spi-gpio.c
@@ -235,7 +235,8 @@
status = gpio_request(cs, dev_name(&spi->dev));
if (status)
return status;
- status = gpio_direction_output(cs, spi->mode & SPI_CS_HIGH);
+ status = gpio_direction_output(cs,
+ !(spi->mode & SPI_CS_HIGH));
}
}
if (!status)