be2net: call ENABLE_VF cmd for Skyhawk-R too
This cmd needs to be sent to FW when enabling VFs (currently used only
for Lancer.) Also, avoid calling the cmd when driver loads and finds that
VFs are already enabled from a previous load.
Signed-off-by: Vasundhara Volam <vasundhara.volam@emulex.com>
Signed-off-by: Sathya Perla <sathya.perla@emulex.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/emulex/benet/be_cmds.c b/drivers/net/ethernet/emulex/benet/be_cmds.c
index 331dfdc..8610530 100644
--- a/drivers/net/ethernet/emulex/benet/be_cmds.c
+++ b/drivers/net/ethernet/emulex/benet/be_cmds.c
@@ -3511,7 +3511,7 @@
struct be_cmd_enable_disable_vf *req;
int status;
- if (!lancer_chip(adapter))
+ if (BEx_chip(adapter))
return 0;
spin_lock_bh(&adapter->mcc_lock);
diff --git a/drivers/net/ethernet/emulex/benet/be_main.c b/drivers/net/ethernet/emulex/benet/be_main.c
index be12987..961e9f0 100644
--- a/drivers/net/ethernet/emulex/benet/be_main.c
+++ b/drivers/net/ethernet/emulex/benet/be_main.c
@@ -2923,7 +2923,8 @@
goto err;
vf_cfg->def_vid = def_vlan;
- be_cmd_enable_vf(adapter, vf + 1);
+ if (!old_vfs)
+ be_cmd_enable_vf(adapter, vf + 1);
}
if (!old_vfs) {