clk: ti: omap5+: dpll: implement errata i810
Errata i810 states that DPLL controller can get stuck while transitioning
to a power saving state, while its M/N ratio is being re-programmed.
As a workaround, before re-programming the M/N ratio, SW has to ensure
the DPLL cannot start an idle state transition. SW can disable DPLL
idling by setting the DPLL AUTO_DPLL_MODE=0 or keeping a clock request
active by setting a dependent clock domain in SW_WKUP.
This errata impacts OMAP5 and DRA7 chips, so enable the errata for these.
Signed-off-by: Tero Kristo <t-kristo@ti.com>
Signed-off-by: Stephen Boyd <sboyd@codeaurora.org>
diff --git a/arch/arm/mach-omap2/clock.c b/arch/arm/mach-omap2/clock.c
index acb60ed..d058125 100644
--- a/arch/arm/mach-omap2/clock.c
+++ b/arch/arm/mach-omap2/clock.c
@@ -225,5 +225,9 @@
if (omap_rev() == OMAP3430_REV_ES1_0)
features.flags |= TI_CLK_DPLL4_DENY_REPROGRAM;
+ /* Errata I810 for omap5 / dra7 */
+ if (soc_is_omap54xx() || soc_is_dra7xx())
+ features.flags |= TI_CLK_ERRATA_I810;
+
ti_clk_setup_features(&features);
}