bcm47xx: prepare to support different buses
Prepare bcm47xx to support different System buses. Before adding
support for bcma it should be possible to build bcm47xx without the
need of ssb. With this patch bcm47xx does not directly contain a
ssb_bus, but a union contain all the supported system buses. As a SoC
just uses one system bus a union is a good choice.
Signed-off-by: Hauke Mehrtens <hauke@hauke-m.de>
Acked-by: Ralf Baechle <ralf@linux-mips.org>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/arch/mips/bcm47xx/wgt634u.c b/arch/mips/bcm47xx/wgt634u.c
index 74d0696..e9f9ec8 100644
--- a/arch/mips/bcm47xx/wgt634u.c
+++ b/arch/mips/bcm47xx/wgt634u.c
@@ -108,7 +108,7 @@
/* Interrupts are shared, check if the current one is
a GPIO interrupt. */
- if (!ssb_chipco_irq_status(&ssb_bcm47xx.chipco,
+ if (!ssb_chipco_irq_status(&bcm47xx_bus.ssb.chipco,
SSB_CHIPCO_IRQ_GPIO))
return IRQ_NONE;
@@ -132,22 +132,26 @@
* machine. Use the MAC address as an heuristic. Netgear Inc. has
* been allocated ranges 00:09:5b:xx:xx:xx and 00:0f:b5:xx:xx:xx.
*/
+ u8 *et0mac;
- u8 *et0mac = ssb_bcm47xx.sprom.et0mac;
+ if (bcm47xx_bus_type != BCM47XX_BUS_TYPE_SSB)
+ return -ENODEV;
+
+ et0mac = bcm47xx_bus.ssb.sprom.et0mac;
if (et0mac[0] == 0x00 &&
((et0mac[1] == 0x09 && et0mac[2] == 0x5b) ||
(et0mac[1] == 0x0f && et0mac[2] == 0xb5))) {
- struct ssb_mipscore *mcore = &ssb_bcm47xx.mipscore;
+ struct ssb_mipscore *mcore = &bcm47xx_bus.ssb.mipscore;
printk(KERN_INFO "WGT634U machine detected.\n");
if (!request_irq(gpio_to_irq(WGT634U_GPIO_RESET),
gpio_interrupt, IRQF_SHARED,
- "WGT634U GPIO", &ssb_bcm47xx.chipco)) {
+ "WGT634U GPIO", &bcm47xx_bus.ssb.chipco)) {
gpio_direction_input(WGT634U_GPIO_RESET);
gpio_intmask(WGT634U_GPIO_RESET, 1);
- ssb_chipco_irq_mask(&ssb_bcm47xx.chipco,
+ ssb_chipco_irq_mask(&bcm47xx_bus.ssb.chipco,
SSB_CHIPCO_IRQ_GPIO,
SSB_CHIPCO_IRQ_GPIO);
}