ath10k: Support different txbf configuration schemes
qca61x4 uses the vdev param as a sole sufficient configuration
for txbf while qca99x0 enables txbf during peer assoc by
combining the vdev param value with peer assoc's vht capabilities
This patch gets the appropriate txbf configuration scheme
before passing the wmi command to enable the same in the firmware.
Signed-off-by: Vivek Natarajan <nataraja@qti.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/ath10k/wmi.h b/drivers/net/wireless/ath/ath10k/wmi.h
index 0d4efc9..754cc33 100644
--- a/drivers/net/wireless/ath/ath10k/wmi.h
+++ b/drivers/net/wireless/ath/ath10k/wmi.h
@@ -6008,6 +6008,12 @@
u32 pref_offchan_bw;
};
+enum wmi_txbf_conf {
+ WMI_TXBF_CONF_UNSUPPORTED,
+ WMI_TXBF_CONF_BEFORE_ASSOC,
+ WMI_TXBF_CONF_AFTER_ASSOC,
+};
+
struct ath10k;
struct ath10k_vif;
struct ath10k_fw_stats_pdev;