bnx2x: prevent masked MCP parities from appearing
During flows which mask block attentions (e.g., register dump) all parities
are masked. However, unlike other blocks the MCP's attention is not masked
inside the block but rather the indication to the driver. If another attention
(e.g., link change) will occour while there's an MCP parity, the driver will
ignore the fact that the parity is masked and erroneously report a parity.
This patch forces the driver to read the MCP masking while checking for
parities.
Signed-off-by: Yuval Mintz <yuvalmin@broadcom.com>
Signed-off-by: Ariel Elior <ariele@broadcom.com>
Signed-off-by: Eilon Greenstein <eilong@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
index f403c6b..82b658d 100644
--- a/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
+++ b/drivers/net/ethernet/broadcom/bnx2x/bnx2x_main.c
@@ -4703,6 +4703,14 @@
attn.sig[3] = REG_RD(bp,
MISC_REG_AEU_AFTER_INVERT_4_FUNC_0 +
port*4);
+ /* Since MCP attentions can't be disabled inside the block, we need to
+ * read AEU registers to see whether they're currently disabled
+ */
+ attn.sig[3] &= ((REG_RD(bp,
+ !port ? MISC_REG_AEU_ENABLE4_FUNC_0_OUT_0
+ : MISC_REG_AEU_ENABLE4_FUNC_1_OUT_0) &
+ MISC_AEU_ENABLE_MCP_PRTY_BITS) |
+ ~MISC_AEU_ENABLE_MCP_PRTY_BITS);
if (!CHIP_IS_E1x(bp))
attn.sig[4] = REG_RD(bp,