clocksource: sh_tmu: __clocksource_updatefreq_hz() update
This patch updates the clocksource part of the TMU driver
to make use of the __clocksource_updatefreq_hz() function.
Without this patch the old code uses clocksource_register()
together with a hack that assumes a never changing clock rate
(see clk_enable(), clk_get_rate() and clk_disable()).
The patch uses clocksource_register_hz() with 1 Hz as initial
value, then lets the ->enable() callback update the value
with __clocksource_updatefreq_hz() once the struct clk has
been enabled and the frequency is stable.
Signed-off-by: Magnus Damm <damm@opensource.se>
Acked-by: John Stultz <johnstul@us.ibm.com>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
diff --git a/drivers/clocksource/sh_tmu.c b/drivers/clocksource/sh_tmu.c
index 36aba99..8081357 100644
--- a/drivers/clocksource/sh_tmu.c
+++ b/drivers/clocksource/sh_tmu.c
@@ -199,8 +199,12 @@
static int sh_tmu_clocksource_enable(struct clocksource *cs)
{
struct sh_tmu_priv *p = cs_to_sh_tmu(cs);
+ int ret;
- return sh_tmu_enable(p);
+ ret = sh_tmu_enable(p);
+ if (!ret)
+ __clocksource_updatefreq_hz(cs, p->rate);
+ return ret;
}
static void sh_tmu_clocksource_disable(struct clocksource *cs)
@@ -221,17 +225,10 @@
cs->mask = CLOCKSOURCE_MASK(32);
cs->flags = CLOCK_SOURCE_IS_CONTINUOUS;
- /* clk_get_rate() needs an enabled clock */
- clk_enable(p->clk);
- /* channel will be configured at parent clock / 4 */
- p->rate = clk_get_rate(p->clk) / 4;
- clk_disable(p->clk);
- /* TODO: calculate good shift from rate and counter bit width */
- cs->shift = 10;
- cs->mult = clocksource_hz2mult(p->rate, cs->shift);
-
dev_info(&p->pdev->dev, "used as clock source\n");
- clocksource_register(cs);
+
+ /* Register with dummy 1 Hz value, gets updated in ->enable() */
+ clocksource_register_hz(cs, 1);
return 0;
}