be2net: do not remove vids from driver table if be_vid_config() fails.
The driver currently removes a new vid from the adapter->vids[] array if
be_vid_config() returns an error, which occurs when there is an error in
HW/FW. This is wrong. After the HW/FW error is recovered from, we need the
complete vids[] array to re-program the vlan list.
Signed-off-by: Sathya Perla <sathya.perla@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ethernet/emulex/benet/be_main.c b/drivers/net/ethernet/emulex/benet/be_main.c
index a97fc8a..243d43b 100644
--- a/drivers/net/ethernet/emulex/benet/be_main.c
+++ b/drivers/net/ethernet/emulex/benet/be_main.c
@@ -1463,13 +1463,7 @@
set_bit(vid, adapter->vids);
adapter->vlans_added++;
- status = be_vid_config(adapter);
- if (status) {
- adapter->vlans_added--;
- clear_bit(vid, adapter->vids);
- }
-
- return status;
+ return be_vid_config(adapter);
}
static int be_vlan_rem_vid(struct net_device *netdev, __be16 proto, u16 vid)