md/raid1: avoid reusing a resync bio after error handling.
fix_sync_read_error() modifies a bio on a newly faulty
device by setting bi_end_io to end_sync_write.
This ensure that put_buf() will still call rdev_dec_pending()
as required, but makes sure that subsequent code in
fix_sync_read_error() doesn't try to read from the device.
Unfortunately this interacts badly with sync_request_write()
which assumes that any bio with bi_end_io set to non-NULL
other than end_sync_read is safe to write to.
As the device is now faulty it doesn't make sense to write.
As the bio was recently used for a read, it is "dirty"
and not suitable for immediate submission.
In particular, ->bi_next might be non-NULL, which will cause
generic_make_request() to complain.
Break this interaction by refusing to write to devices
which are marked as Faulty.
Reported-and-tested-by: Michael Wang <yun.wang@profitbricks.com>
Fixes: 2e52d449bcec ("md/raid1: add failfast handling for reads.")
Cc: stable@vger.kernel.org (v4.10+)
Signed-off-by: NeilBrown <neilb@suse.com>
Signed-off-by: Shaohua Li <shli@fb.com>
diff --git a/drivers/md/raid1.c b/drivers/md/raid1.c
index 7d67235..70278b9 100644
--- a/drivers/md/raid1.c
+++ b/drivers/md/raid1.c
@@ -2218,6 +2218,8 @@ static void sync_request_write(struct mddev *mddev, struct r1bio *r1_bio)
(i == r1_bio->read_disk ||
!test_bit(MD_RECOVERY_SYNC, &mddev->recovery))))
continue;
+ if (test_bit(Faulty, &conf->mirrors[i].rdev->flags))
+ continue;
bio_set_op_attrs(wbio, REQ_OP_WRITE, 0);
if (test_bit(FailFast, &conf->mirrors[i].rdev->flags))